[fedora-arm] Freescale boot kernel

[Henrik Nordström]

sön 2011-10-02 klockan 16:09 -0700 skrev webwillow at thewebwillow.com:

> ext2load mmc 0:1 0x70800000 /boot/uImage-2.6.39.3-sheevaplug; bootm
> 0x70800000

Is this the right load address for your hardware? It's not the load
address the original boot command used from what I remember.

> Notice the name on the uImage which is a kernel i compiled with a
> modified kernel built with a modied kirkwood config...

Is this kernel built for your board?
 
> Do i need to compile another kernel with seperate config for the
> freescale device with arm7 instead of armv5tel?

You need a kernel that is built for your board type. If your CPU is arm7
then an arm7 kernel is preferred (required?) even if you will just run
armv5tel userspace.

> also, when using the "mmc 0:1" how do i change those parameters to
> load from mmc slot 2 "big slot" instead of the small mmc slot. 

Probably something like

  mmc init 1
  ext2load mmc 1:1 ....

Regards
Henrik