Fwd: New question: Beagleboard XM rev C performance on Ask Linaro

[Andy Doan]

As per the question below. I don't think we ever supported accelerated
graphics for Beagle? ie - there's not some install-binaries.sh like we
have for Panda

-andy

-------- Original Message --------
Subject: 	New question: Beagleboard XM rev C performance on Ask Linaro
Date: 	Fri, 13 Jan 2012 06:40:58 -0800 (PST)
From: 	Ask Linaro <dnsadmin at linaro.org>
To: 	doanac <andy.doan at linaro.org>



Ask Linaro - Q & A forum for Linaro developers <http://ask.linaro.org/>
------------------------------------------------------------------------

Hello doanac,

Leonardo Araujo <http://ask.linaro.org/users/182/leonardo-araujo> has
just posted a new question on Ask Linaro, entitled Beagleboard XM rev C
performance
<http://ask.linaro.org/questions/529/beagleboard-xm-rev-c-performance>
and tagged "/android <http://ask.linaro.org/tags/android/> beagleboard
<http://ask.linaro.org/tags/beagleboard/> performance
<http://ask.linaro.org/tags/performance/> xm
<http://ask.linaro.org/tags/xm/>/". Here's what it says:

    Hi guys I've successfully run linaro android in my Beagleboard XM
    rev C, but by some reason it's has a very slow performance and I
    can't test any 3d application, this could be due to the fact that
    hardware acceleration is disabled? And how can I enable it?

    Thanks bellow are the commands that I've used to install Android on
    the SD card

    Some times I'm getting these messages on the console: *[ 26.735809]
    omap_device: omap_hsmmc.0: new worst case activate latency 0: 274658*

    $ wget --no-check-certificate

https://android-build.linaro.org/jenkins/job/linaro-android_beagle-11.10-release/4/artifact/build/out/target/product/beagleboard/boot.tar.bz2
    $ wget

https://android-build.linaro.org/jenkins/job/linaro-android_beagle-11.10-release/4/artifact/build/out/target/product/beagleboard/system.tar.bz2
    $ wget

https://android-build.linaro.org/jenkins/job/linaro-android_beagle-11.10-release/4/artifact/build/out/target/product/beagleboard/userdata.tar.bz2

    sudo ./linaro-image-tools/linaro-android-media-create --mmc /dev/sdd
    --dev beagle --system system.tar.bz2 --userdata userdata.tar.bz2
    --boot boot.tar.bz2

Don't forget to come over and cast your vote.

Thanks,
Ask Linaro

P.S. You can always fine-tune which notifications you receive here
<http://ask.linaro.org//users/16/doanac/subscriptions/>.

------------------------------------------------------------------------