[PATCH] usb: musb: ux500: set dma config for both src and dst

[Mian Yousaf Kaukab]

On 08/02/2011 05:33 PM, Per FORLIN wrote:
> From: Per Forlin<per.forlin at linaro.org>
>
> The dma driver requires both src and dst to be set.
> This fix is needed in order to run gadget mass storage.
> Patch is verified on snowball.
>
> Signed-off-by: Per Forlin<per.forlin at linaro.org>
> ---
>   drivers/usb/musb/ux500_dma.c |   16 +++++++---------
>   1 files changed, 7 insertions(+), 9 deletions(-)
>
> diff --git a/drivers/usb/musb/ux500_dma.c b/drivers/usb/musb/ux500_dma.c
> index cecace4..2313475 100644
> --- a/drivers/usb/musb/ux500_dma.c
> +++ b/drivers/usb/musb/ux500_dma.c
> @@ -133,15 +133,13 @@ static bool ux500_configure_channel(struct dma_channel *channel,
>   					DMA_SLAVE_BUSWIDTH_4_BYTES;
>
>   	slave_conf.direction = direction;
> -	if (direction == DMA_FROM_DEVICE) {
> -		slave_conf.src_addr = usb_fifo_addr;
> -		slave_conf.src_addr_width = addr_width;
> -		slave_conf.src_maxburst = 16;
> -	} else {
> -		slave_conf.dst_addr = usb_fifo_addr;
> -		slave_conf.dst_addr_width = addr_width;
> -		slave_conf.dst_maxburst = 16;
> -	}
> +	slave_conf.src_addr = usb_fifo_addr;
> +	slave_conf.src_addr_width = addr_width;
> +	slave_conf.src_maxburst = 16;
> +	slave_conf.dst_addr = usb_fifo_addr;
> +	slave_conf.dst_addr_width = addr_width;
> +	slave_conf.dst_maxburst = 16;
> +
>   	dma_chan->device->device_control(dma_chan, DMA_SLAVE_CONFIG,
>   					     (unsigned long)&slave_conf);
>
>    

Acked-by: Mian Yousaf Kaukab <mian.yousaf.kaukab at stericsson.com>

Thanks,

-- 
Mian Yousaf Kaukab