Hi,

Thanks!  Any advice on kernel build configs I should use for the SABRE?


Regards,

Tim


-------- Original message -------- Subject: Re: Linaro ICS on i.MX53 SABRE tablet From: Bernhard Rosenkränzer To: tskutt@yahoo.com CC: linaro-android@lists.linaro.org

Hi,

On 25 May 2012 21:10, Timothy Skutt <tskutt@yahoo.com> wrote:
> I built 12.04 per the instructions for i.MX53 and tried it on my i.MX53
> SABRE tablet, but after u-boot loads the uImage and uIinitrd and then boots
> the kernel I get no output from the kernel.

That is to be expected, because the build if for the i.MX53 QuickStart
board, not the SABRE.

They are largely, but not fully, identical. Chances are all you have
to replace is the kernel. (I don't have a SABRE though, so can't tell
for sure.)

ttyl
bero