Hi,
I'm seeing this when booting up the iMX6 board with the current build
(strangely enough, the first build didn't do this):


<6>mmc0: new high speed SDHC card at address e624
<6>mmcblk0: mmc0:e624 SD32G 29.7 GiB
<6> mmcblk0: p1 p2 p3 p4 < p5 p6 p7 >
<6>EXT4-fs (mmcblk0p3): mounted filesystem with ordered data mode. Opts: (null)
<6>EXT4-fs (mmcblk0p5): recovery complete
<6>EXT4-fs (mmcblk0p5): mounted filesystem with ordered data mode. Opts: (null)
<6>EXT4-fs (mmcblk0p6): recovery complete
<6>EXT4-fs (mmcblk0p6): mounted filesystem with ordered data mode. Opts: (null)
[ Up to here, this is expected and just given as context ]
<4>Disabling lock debugging due to kernel taint
<3>init: service 'console' requires console
<3>init: cannot find '/system/etc/install-recovery.sh', disabling
'flash_recovery'
<3>init: service 'console' requires console
<6>warning: `rild' uses 32-bit capabilities (legacy support in use)


After that, it goes on and boots Android fine, everything works
nicely. But there is no console on the serial port.
Has anyone run into that "init: service 'console' requires console"
thing before?

ttyl
bero

_______________________________________________
linaro-android mailing list
linaro-android@lists.linaro.org
http://lists.linaro.org/mailman/listinfo/linaro-android