Hi Praveen,

Insert an SD card
Run 'dmesg' and look for a line that looks like
[288582.790722]  sdc: sdc1 sdc2 sdc3 sdc4 < sdc5 sdc6 >
Run the tip of linaro image tools
./linaro-image-tools/linaro-android-media-create --mmc /dev/sdc --dev panda --system system.tar.bz2 --userdata userdata.tar.bz2 --boot boot.tar.bz2
Regards,
Vishal

On 9 August 2012 09:35, praween kr <praween.erk@gmail.com> wrote:
Hi,

I'm very new to Android porting .I have PandaBoard Revision B1 . I have all the images of latest build 151 of Panda board. I started following the procedure as provided to flash the pre-built image.

I'm stuck with writing data to SDcard as , the command provided is little tricky and no completely understandable. Can you please provide me the SDCard format  type (ext2,ext3,FAT,NTFS....)for writing the data in more details. I'm completely unclear with the command provided in procedure.

# Create media (this assumes your SD card is /dev/mmcblk0, you may have to replace the device name)
$ bzr branch lp:~vishalbhoj/linaro-image-tools/panda-dt 
$ sudo panda-dt/linaro-android-media-create --dev panda --mmc /dev/mmcblk0 --system system.tar.bz2 --userdata userdata.tar.bz2 --boot boot.tar.bz2


Waiting for your reply eagerly. Thank you.
--
Praween kr.
Android Geek
                  http://www.plurk.com/t/English#hot


_______________________________________________
linaro-android mailing list
linaro-android@lists.linaro.org
http://lists.linaro.org/mailman/listinfo/linaro-android