Trying 127.0.0.1... Connected to localhost. Escape character is '^]'. Linux version 2.6.35.8-arm1-ds5 (psg@spongebob) (gcc version 4.5.2 (Sourcery G++ Lite 2011.03-41) ) #3 Tue Sep 13 16:38:17 BST 2011 CPU: ARMv7 Processor [412fc081] revision 1 (ARMv7), cr=10c5387f CPU: VIPT nonaliasing data cache, VIPT nonaliasing instruction cache Machine: ARM-RealView EB Memory policy: ECC disabled, Data cache writeback Built 1 zonelists in Zone order, mobility grouping on. Total pages: 65024 Kernel command line: root=/dev/nfs rw nfsroot=10.1.72.151:/home/psg/Downloads/fsfull rootwait ip=dhcp mem=256M console=ttyAMA0 PID hash table entries: 1024 (order: 0, 4096 bytes) Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) Memory: 256MB = 256MB total Memory: 255304k/255304k available, 6840k reserved, 0K highmem Virtual kernel memory layout: vector : 0xffff0000 - 0xffff1000 ( 4 kB) fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB) DMA : 0xffc00000 - 0xffe00000 ( 2 MB) vmalloc : 0xd0800000 - 0xf8000000 ( 632 MB) lowmem : 0xc0000000 - 0xd0000000 ( 256 MB) pkmap : 0xbfe00000 - 0xc0000000 ( 2 MB) modules : 0xbf000000 - 0xbfe00000 ( 14 MB) .init : 0xc0008000 - 0xc002b000 ( 140 kB) .text : 0xc002b000 - 0xc03f9000 (3896 kB) .data : 0xc0412000 - 0xc0436160 ( 145 kB) SLUB: Genslabs=11, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 Hierarchical RCU implementation. RCU-based detection of stalled CPUs is disabled. Verbose stalled-CPUs detection is disabled. NR_IRQS:128 Console: colour dummy device 80x30 Calibrating delay loop... 124.51 BogoMIPS (lpj=622592) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok NET: Registered protocol family 16 Serial: AMBA PL011 UART driver dev:uart0: ttyAMA0 at MMIO 0x10009000 (irq = 44) is a AMBA/PL011 console [ttyAMA0] enabled dev:uart1: ttyAMA1 at MMIO 0x1000a000 (irq = 45) is a AMBA/PL011 dev:uart2: ttyAMA2 at MMIO 0x1000b000 (irq = 46) is a AMBA/PL011 fpga:uart3: ttyAMA3 at MMIO 0x1000c000 (irq = 47) is a AMBA/PL011 bio: create slab at 0 SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb Advanced Linux Sound Architecture Driver Version 1.0.23. Switching to clocksource timer3 NET: Registered protocol family 2 IP route cache hash table entries: 2048 (order: 1, 8192 bytes) TCP established hash table entries: 8192 (order: 4, 65536 bytes) TCP bind hash table entries: 8192 (order: 3, 32768 bytes) TCP: Hash tables configured (established 8192 bind 8192) TCP reno registered UDP hash table entries: 256 (order: 0, 4096 bytes) UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) NET: Registered protocol family 1 RPC: Registered udp transport module. RPC: Registered tcp transport module. RPC: Registered tcp NFSv4.1 backchannel transport module. msgmni has been set to 498 io scheduler noop registered io scheduler cfq registered (default) CLCD: unknown LCD panel ID 0x00000100, using VGA CLCD: RealView hardware, VGA display Console: switching to colour frame buffer device 80x30 brd: module loaded smc91x: IOADDR d0878000 doesn't match configuration (300). smc91x.c: v1.1, sep 22 2004 by Nicolas Pitre eth0: SMC91C11xFD (rev 1) at d0878000 IRQ 60 [nowait] eth0: Ethernet addr: 00:02:f7:ef:06:88 isp1760 isp1760.0: NXP ISP1760 USB Host Controller isp1760 isp1760.0: new USB bus registered, assigned bus number 1 ISP1760: Scratch test failed. isp1760 isp1760.0: can't setup isp1760 isp1760.0: USB bus 1 deregistered isp1760: Failed to register the HCD device Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. mice: PS/2 mouse device common for all mice rtc-pl031 dev:rtc: rtc core: registered pl031 as rtc0 mmci-pl18x fpga:mmc0: mmc0: MMCI rev 0 cfg 00 at 0x0000000010005000 irq 49,50 usbcore: registered new interface driver usbhid usbhid: USB HID core driver mmc0: new MMC card at address 0001 aaci-pl041 fpga:aaci: ARM AC'97 Interface at 0x0000000010004000, irq 51, fifo 512 mmcblk0: mmc0:0001 ARMmm256 MiB mmcblk0: ALSA device list: #0: ARM AC'97 Interface at 0x0000000010004000, irq 51 TCP cubic registered NET: Registered protocol family 17 unknown partition table VFP support v0.3: implementor 41 architecture 3 part 30 variant c rev 2 ThumbEE CPU extension supported. Registering SWP/SWPB emulation handler rtc-pl031 dev:rtc: setting system clock to 1970-01-01 00:00:00 UTC (0) input: AT Raw Set 2 keyboard as /devices/fpga:kmi0/serio0/input/input0 eth0: link up, 10Mbps, half-duplex, lpa 0x0000 input: PS/2 Generic Mouse as /devices/fpga:kmi1/serio1/input/input1 Sending DHCP requests ...., OK IP-Config: Got DHCP answer from 10.1.79.54, my address is 10.1.72.160 IP-Config: Complete: device=eth0, addr=10.1.72.160, mask=255.255.255.0, gw=10.1.72.1, host=10.1.72.160, domain=cambridge.arm.com, nis-domain=(none), bootserver=10.1.79.54, rootserver=10.1.72.151, rootpath= Looking up port of RPC 100003/2 on 10.1.72.151 Looking up port of RPC 100005/1 on 10.1.72.151 VFS: Mounted root (nfs filesystem) on device 0:11. Freeing init memory: 140K init: ureadahead main process (454) terminated with status 5 mount.nfs: remote share not in 'host:dir' format mountall: mount / [460] terminated with status 32