From: Kunihiko Hayashi hayashi.kunihiko@socionext.com
[ Upstream commit dcabb06bf127b3e0d3fbc94a2b65dd56c2725851 ]
UniPhier LD20 and PXs3 boards have RTL8211E ethernet phy, and the phy have the RX/TX delays of RGMII interface using pull-ups on the RXDLY and TXDLY pins.
After the commit bbc4d71d6354 ("net: phy: realtek: fix rtl8211e rx/tx delay config"), the delays are working correctly, however, "rgmii" means no delay and the phy doesn't work. So need to set the phy-mode to "rgmii-id" to show that RX/TX delays are enabled.
Fixes: c73730ee4c9a ("arm64: dts: uniphier: add AVE ethernet node") Signed-off-by: Kunihiko Hayashi hayashi.kunihiko@socionext.com Signed-off-by: David S. Miller davem@davemloft.net Signed-off-by: Sasha Levin sashal@kernel.org --- arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi | 2 +- arch/arm64/boot/dts/socionext/uniphier-pxs3.dtsi | 4 ++-- 2 files changed, 3 insertions(+), 3 deletions(-)
diff --git a/arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi b/arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi index a87b8a678719..8f2c1c1e2c64 100644 --- a/arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi +++ b/arch/arm64/boot/dts/socionext/uniphier-ld20.dtsi @@ -734,7 +734,7 @@ clocks = <&sys_clk 6>; reset-names = "ether"; resets = <&sys_rst 6>; - phy-mode = "rgmii"; + phy-mode = "rgmii-id"; local-mac-address = [00 00 00 00 00 00]; socionext,syscon-phy-mode = <&soc_glue 0>;
diff --git a/arch/arm64/boot/dts/socionext/uniphier-pxs3.dtsi b/arch/arm64/boot/dts/socionext/uniphier-pxs3.dtsi index 0e52dadf54b3..be97da132258 100644 --- a/arch/arm64/boot/dts/socionext/uniphier-pxs3.dtsi +++ b/arch/arm64/boot/dts/socionext/uniphier-pxs3.dtsi @@ -564,7 +564,7 @@ clocks = <&sys_clk 6>; reset-names = "ether"; resets = <&sys_rst 6>; - phy-mode = "rgmii"; + phy-mode = "rgmii-id"; local-mac-address = [00 00 00 00 00 00]; socionext,syscon-phy-mode = <&soc_glue 0>;
@@ -585,7 +585,7 @@ clocks = <&sys_clk 7>; reset-names = "ether"; resets = <&sys_rst 7>; - phy-mode = "rgmii"; + phy-mode = "rgmii-id"; local-mac-address = [00 00 00 00 00 00]; socionext,syscon-phy-mode = <&soc_glue 1>;