Help-
I have a new Panda board (the box label says UEVM4460G-02-01-00) with a 16 GB SD card and DVI monitor, with Ubuntu 10.04 as the dev platform.
I have been trying a number of different pre-built Android binaries (starting at pandaboard.org and following instructions there (Quickstart with pre-built binaries) which takes me to omappedia and linaro, but can't seem to get any to come to full running status.
The release with most success is 12.03, but as soon as the "Android" shimmer screen is replaced with the Android environment, a window pops up to say "Unfortunately, Launcher has stopped". Some green blocks are moving about the screen at approx a one second interval, and moving the mouse causes the cursor to move very slowly, in sync with the green block movements.
A few icons are shown at bottom left, and time of day is shown at bottom right. Nothing else is visible on the screen.
Pressing the reset button cause a reboot, but this time it gets no further than the Android shimmer screen. The TTY console shows what appears to be an endless loop of a few dozen events, all seeming to repeat themselves.
Not sure what details are needed to get past this problem, any help would be most appreciated.
I have also tried releases 12.01, 12.02, and 11.11. None of these even show anything on the monitor.
Thanks, Ron
____________________________________________________________ 53 Year Old Mom Looks 33 The Stunning Results of Her Wrinkle Trick Has Botox Doctors Worried http://thirdpartyoffers.juno.com/TGL3131/4f94bdbf27e2681f827st01vuc