14 Jun
2015
14 Jun
'15
1:57 p.m.
On 06/14/2015 03:05 AM, Fu Wei wrote:
On 13 June 2015 at 04:54, Timur Tabi timur@codeaurora.org wrote:
On 06/10/2015 12:47 PM, fu.wei@linaro.org wrote:
reg = <0x0 0xe0bb0000 0 0x10000>,<0x0 0xe0bc0000 0 0x10000>;I think the sizes are wrong. They should be 0x1000 instead of 0x10000.
This has been proved by test, it works well on Seattle Foundation model has same value. So I don't think it is wrong
otherwise someone has the data sheet of Seattle B0, and it shows that is wrong.
If only 0x1000 is used, why would you have to reserve 0x10000 ? You never access any higher addresses, so no matter what the datasheet says, 0x1000 should be sufficient. What matters is what the driver uses.
Guenter