In switch_hrtimer_base() we are calling hrtimer_check_target() which guarantees this:
/* * With HIGHRES=y we do not migrate the timer when it is expiring * before the next event on the target cpu because we cannot reprogram * the target cpu hardware and we would cause it to fire late. * * Called with cpu_base->lock of target cpu held. */
But switch_hrtimer_base() is only called from one place, i.e. __hrtimer_start_range_ns() and at that point (where we call switch_hrtimer_base()) expiration time is not yet known as we call this routine later: hrtimer_set_expires_range_ns().
To fix this, we need to find the updated expiry time before calling switch_hrtimer_base().
Signed-off-by: Viresh Kumar viresh.kumar@linaro.org --- Rebased over: v3.15-rc5
kernel/hrtimer.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/kernel/hrtimer.c b/kernel/hrtimer.c index 6b715c0..e0501fe 100644 --- a/kernel/hrtimer.c +++ b/kernel/hrtimer.c @@ -990,11 +990,8 @@ int __hrtimer_start_range_ns(struct hrtimer *timer, ktime_t tim, /* Remove an active timer from the queue: */ ret = remove_hrtimer(timer, base);
- /* Switch the timer base, if necessary: */ - new_base = switch_hrtimer_base(timer, base, mode & HRTIMER_MODE_PINNED); - if (mode & HRTIMER_MODE_REL) { - tim = ktime_add_safe(tim, new_base->get_time()); + tim = ktime_add_safe(tim, base->get_time()); /* * CONFIG_TIME_LOW_RES is a temporary way for architectures * to signal that they simply return xtime in @@ -1009,6 +1006,9 @@ int __hrtimer_start_range_ns(struct hrtimer *timer, ktime_t tim,
hrtimer_set_expires_range_ns(timer, tim, delta_ns);
+ /* Switch the timer base, if necessary: */ + new_base = switch_hrtimer_base(timer, base, mode & HRTIMER_MODE_PINNED); + timer_stats_hrtimer_set_start_info(timer);
leftmost = enqueue_hrtimer(timer, new_base);