If the regulators aren't set explicitly by the platform, the OPP core assumes that the platform doesn't have any regulator and uses the clk-only callback.
If the platform failed to register a regulator with the core, then this can turn out to be a dangerous assumption as the OPP core will try to change clk without changing regulators.
Handle that properly by making sure that the DT didn't have any entries for supply voltages as well.
Signed-off-by: Viresh Kumar viresh.kumar@linaro.org --- V4: - s/had/have - fix missing rcu_read_unlock()
drivers/base/power/opp/core.c | 13 +++++++++++++ 1 file changed, 13 insertions(+)
diff --git a/drivers/base/power/opp/core.c b/drivers/base/power/opp/core.c index 3298fac01bb0..cb33f8b2b56d 100644 --- a/drivers/base/power/opp/core.c +++ b/drivers/base/power/opp/core.c @@ -734,7 +734,20 @@ int dev_pm_opp_set_rate(struct device *dev, unsigned long target_freq)
/* Only frequency scaling */ if (!regulators) { + unsigned long u_volt = opp->supplies[0].u_volt; + rcu_read_unlock(); + + /* + * DT contained supply ratings? Consider platform failed to set + * regulators. + */ + if (unlikely(u_volt)) { + dev_err(dev, "%s: Regulator not registered with OPP core\n", + __func__); + return -EINVAL; + } + return _generic_set_opp_clk_only(dev, clk, old_freq, freq); }