On 04-06-20, 03:43, Dmitry Baryshkov wrote:
Add base DTS file for pm8009 along with GPIOs and power-on nodes.
Signed-off-by: Dmitry Baryshkov dmitry.baryshkov@linaro.org
arch/arm64/boot/dts/qcom/pm8009.dtsi | 40 ++++++++++++++++++++++++++++ 1 file changed, 40 insertions(+) create mode 100644 arch/arm64/boot/dts/qcom/pm8009.dtsi
diff --git a/arch/arm64/boot/dts/qcom/pm8009.dtsi b/arch/arm64/boot/dts/qcom/pm8009.dtsi new file mode 100644 index 000000000000..9f3e19b5bd00 --- /dev/null +++ b/arch/arm64/boot/dts/qcom/pm8009.dtsi @@ -0,0 +1,40 @@ +// SPDX-License-Identifier: BSD-3-Clause +/*
- Copyright (c) 2017-2019, The Linux Foundation. All rights reserved.
- Copyright (c) 2019, Linaro Limited
We are in 2020 :)
- */
+#include <dt-bindings/input/input.h> +#include <dt-bindings/interrupt-controller/irq.h>
DO you need these headers for base patch, we should add them when adding uses of this file
+#include <dt-bindings/spmi/spmi.h> +#include <dt-bindings/iio/qcom,spmi-vadc.h>
This one too
+&spmi_bus {
- pmic@a {
compatible = "qcom,pm8009", "qcom,spmi-pmic";reg = <0xa SPMI_USID>;#address-cells = <1>;#size-cells = <0>;power-on@800 {compatible = "qcom,pm8916-pon";reg = <0x0800>;};pm8009_gpios: gpio@c000 {compatible = "qcom,pm8005-gpio";reg = <0xc000>;gpio-controller;#gpio-cells = <2>;interrupt-controller;#interrupt-cells = <2>;};- };
- pmic@b {
compatible = "qcom,pm8009", "qcom,spmi-pmic";reg = <0xb SPMI_USID>;#address-cells = <1>;#size-cells = <0>;- };
+};
2.26.2