Hi Peter,

I had little mistake in the doc.

------ $sudo cp tty1.conf ttyAMA0.conf $sudo vi tty0.conf ------

should be

------ $sudo cp tty1.conf ttyAMA0.conf $sudo vi ttyAMA0.conf ------

Thanks,

Akira

On 08/31/2012 12:13 PM, Akira Tsukamoto wrote:

Hi Peter,

I am exactly working on the same what you are trying to do. So far, I was able to boot Nano Oneric Linaro evaluation build. Attached some instructions.

The entire procedure of steps for booting Nano Oneric LEB on the FatModels: Nano-Oneric-s.txt Device tree source for the FastModels mentioned in the Nano-Oneric.txt rtsm_ve-cortex_a15x2_32.dts Config file to build the kernel mentioned in the Nano-Oneric.txt vexpress_rtsm_defconfig_3.4.7-2 Patch to fix issue on setting up bridge network for the FastModels which is mentioned in the Nano-Oneric.txt ModelNetworking_setup_sh_Linaro_1.patch

I hope this helps.

Thank you and best regards,

Akira

On 08/30/2012 07:40 AM, Peter Chang wrote:

...

Dear Kernel developer of Linaro:

We've bought FastModel to simulate Cortex-A15. But we cannot find out the Linux for running on Cortex-A15. I've also downloaded the latest Linaro Linux from website. But I still cannot find the default configure for Cortex-A15. Is there anyone working for Linaro Linux for Cortex-A15? And is it released? Thank for answer my question.

Best wish, Peter Chang _______________________________________________ linaro-kernel mailing list linaro-kernel@lists.linaro.org http://lists.linaro.org/mailman/listinfo/linaro-kernel