4.16-stable review patch. If anyone has any objections, please let me know.
------------------
From: Miquel Raynal miquel.raynal@bootlin.com
commit a2ee41fd953e7c3ff6c55a3038c80354d191a318 upstream.
One layout supported by the Marvell NAND controller supports NAND pages of 2048 bytes, all handled in one single chunk when using BCH with a strength of 4-bit per 512 bytes. In this case, instead of the generic XTYPE_WRITE_DISPATCH/XTYPE_LAST_NAKED_RW couple, the controller expects to receive XTYPE_MONOLITHIC_RW.
This fixes problems at boot like:
[ 1.315475] Scanning device for bad blocks [ 3.203108] marvell-nfc f10d0000.flash: Timeout waiting for RB signal [ 3.209564] nand_bbt: error while writing BBT block -110 [ 4.243106] marvell-nfc f10d0000.flash: Timeout waiting for RB signal [ 5.283106] marvell-nfc f10d0000.flash: Timeout waiting for RB signal [ 5.289562] nand_bbt: error -110 while marking block 2047 bad [ 6.323106] marvell-nfc f10d0000.flash: Timeout waiting for RB signal [ 6.329559] nand_bbt: error while writing BBT block -110 [ 7.363106] marvell-nfc f10d0000.flash: Timeout waiting for RB signal [ 8.403105] marvell-nfc f10d0000.flash: Timeout waiting for RB signal [ 8.409559] nand_bbt: error -110 while marking block 2046 bad ...
Fixes: 02f26ecf8c772 ("mtd: nand: add reworked Marvell NAND controller driver") Cc: stable@vger.kernel.org Signed-off-by: Miquel Raynal miquel.raynal@bootlin.com Tested-by: Chris Packham chris.packham@alliedtelesis.co.nz Signed-off-by: Boris Brezillon boris.brezillon@bootlin.com Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org
--- drivers/mtd/nand/marvell_nand.c | 8 +++++++- 1 file changed, 7 insertions(+), 1 deletion(-)
--- a/drivers/mtd/nand/marvell_nand.c +++ b/drivers/mtd/nand/marvell_nand.c @@ -1404,6 +1404,7 @@ marvell_nfc_hw_ecc_bch_write_chunk(struc struct marvell_nand_chip *marvell_nand = to_marvell_nand(chip); struct marvell_nfc *nfc = to_marvell_nfc(chip->controller); const struct marvell_hw_ecc_layout *lt = to_marvell_nand(chip)->layout; + u32 xtype; int ret; struct marvell_nfc_op nfc_op = { .ndcb[0] = NDCB0_CMD_TYPE(TYPE_WRITE) | NDCB0_LEN_OVRD, @@ -1419,7 +1420,12 @@ marvell_nfc_hw_ecc_bch_write_chunk(struc * last naked write. */ if (chunk == 0) { - nfc_op.ndcb[0] |= NDCB0_CMD_XTYPE(XTYPE_WRITE_DISPATCH) | + if (lt->nchunks == 1) + xtype = XTYPE_MONOLITHIC_RW; + else + xtype = XTYPE_WRITE_DISPATCH; + + nfc_op.ndcb[0] |= NDCB0_CMD_XTYPE(xtype) | NDCB0_ADDR_CYC(marvell_nand->addr_cyc) | NDCB0_CMD1(NAND_CMD_SEQIN); nfc_op.ndcb[1] |= NDCB1_ADDRS_PAGE(page);