From: Stephane Grosjean s.grosjean@peak-system.com
The DMA logic in firmwares < v3.3.0 embedded in the PCAN-PCIe FD cards family is not capable of handling a mix of 32-bit and 64-bit logical addresses. If the board is equipped with 2 or 4 CAN ports, then such a situation might lead to a PCIe Bus Error "Malformed TLP" packet as well as "irq xx: nobody cared" issue.
This patch adds a workaround that requests only 32-bit DMA addresses when these might be allocated outside of the 4 GB area.
This issue has been fixed in firmware v3.3.0 and next.
Signed-off-by: Stephane Grosjean s.grosjean@peak-system.com Cc: linux-stable stable@vger.kernel.org Signed-off-by: Marc Kleine-Budde mkl@pengutronix.de --- drivers/net/can/peak_canfd/peak_pciefd_main.c | 19 +++++++++++++++++++ 1 file changed, 19 insertions(+)
diff --git a/drivers/net/can/peak_canfd/peak_pciefd_main.c b/drivers/net/can/peak_canfd/peak_pciefd_main.c index b9e28578bc7b..455a3797a200 100644 --- a/drivers/net/can/peak_canfd/peak_pciefd_main.c +++ b/drivers/net/can/peak_canfd/peak_pciefd_main.c @@ -58,6 +58,10 @@ MODULE_LICENSE("GPL v2"); #define PCIEFD_REG_SYS_VER1 0x0040 /* version reg #1 */ #define PCIEFD_REG_SYS_VER2 0x0044 /* version reg #2 */
+#define PCIEFD_FW_VERSION(x, y, z) (((u32)(x) << 24) | \ + ((u32)(y) << 16) | \ + ((u32)(z) << 8)) + /* System Control Registers Bits */ #define PCIEFD_SYS_CTL_TS_RST 0x00000001 /* timestamp clock */ #define PCIEFD_SYS_CTL_CLK_EN 0x00000002 /* system clock */ @@ -782,6 +786,21 @@ static int peak_pciefd_probe(struct pci_dev *pdev, "%ux CAN-FD PCAN-PCIe FPGA v%u.%u.%u:\n", can_count, hw_ver_major, hw_ver_minor, hw_ver_sub);
+#ifdef CONFIG_ARCH_DMA_ADDR_T_64BIT + /* FW < v3.3.0 DMA logic doesn't handle correctly the mix of 32-bit and + * 64-bit logical addresses: this workaround forces usage of 32-bit + * DMA addresses only when such a fw is detected. + */ + if (PCIEFD_FW_VERSION(hw_ver_major, hw_ver_minor, hw_ver_sub) < + PCIEFD_FW_VERSION(3, 3, 0)) { + err = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(32)); + if (err) + dev_warn(&pdev->dev, + "warning: can't set DMA mask %llxh (err %d)\n", + DMA_BIT_MASK(32), err); + } +#endif + /* stop system clock */ pciefd_sys_writereg(pciefd, PCIEFD_SYS_CTL_CLK_EN, PCIEFD_REG_SYS_CTL_CLR);