From: Claudiu Beznea claudiu.beznea.uj@bp.renesas.com
In the sh-sci driver, serial ports are mapped to the sci_ports[] array, with earlycon mapped at index zero.
The uart_add_one_port() function eventually calls __device_attach(), which, in turn, calls pm_request_idle(). The identified code path is as follows:
uart_add_one_port() -> serial_ctrl_register_port() -> serial_core_register_port() -> serial_core_port_device_add() -> serial_base_port_add() -> device_add() -> bus_probe_device() -> device_initial_probe() -> __device_attach() -> // ... if (dev->p->dead) { // ... } else if (dev->driver) { // ... } else { // ... pm_request_idle(dev); // ... }
The earlycon device clocks are enabled by the bootloader. However, the pm_request_idle() call in __device_attach() disables the SCI port clocks while earlycon is still active.
The earlycon write function, serial_console_write(), calls sci_poll_put_char() via serial_console_putchar(). If the SCI port clocks are disabled, writing to earlycon may sometimes cause the SR.TDFE bit to remain unset indefinitely, causing the while loop in sci_poll_put_char() to never exit. On single-core SoCs, this can result in the system being blocked during boot when this issue occurs.
To resolve this, increment the runtime PM usage counter for the earlycon SCI device before registering the UART port.
Fixes: 0b0cced19ab1 ("serial: sh-sci: Add CONFIG_SERIAL_EARLYCON support") Cc: stable@vger.kernel.org Signed-off-by: Claudiu Beznea claudiu.beznea.uj@bp.renesas.com --- drivers/tty/serial/sh-sci.c | 17 +++++++++++++++++ 1 file changed, 17 insertions(+)
diff --git a/drivers/tty/serial/sh-sci.c b/drivers/tty/serial/sh-sci.c index f74eb68774ca..6acdc8588d2d 100644 --- a/drivers/tty/serial/sh-sci.c +++ b/drivers/tty/serial/sh-sci.c @@ -3435,7 +3435,24 @@ static int sci_probe_single(struct platform_device *dev, sciport->port.flags |= UPF_HARD_FLOW; }
+ /* + * In case: + * - this is the earlycon port (mapped on index 0 in sci_ports[]) and + * - it now maps to an alias other than zero and + * - the earlycon is still alive (e.g., "earlycon keep_bootcon" is + * available in bootargs) + * + * we need to avoid disabling clocks and PM domains through the runtime + * PM APIs called in __device_attach(). For this, increment the runtime + * PM reference counter (the clocks and PM domains were already enabled + * by the bootloader). Otherwise the earlycon may access the HW when it + * has no clocks enabled leading to failures (infinite loop in + * sci_poll_put_char()). + */ + if (sci_ports[0].earlycon && sci_ports[0].port.mapbase == sci_res->start) { + pm_runtime_get_noresume(&dev->dev); + /* * Skip cleanup up the sci_port[0] in early_console_exit(), this * port is the same as the earlycon one.