From: Mariusz Tkaczyk mariusz.tkaczyk@intel.com
[ Upstream commit 9642fa73d073527b0cbc337cc17a47d545d82cd2 ]
Stopping external metadata arrays during resync/recovery causes retries, loop of interrupting and starting reconstruction, until it hit at good moment to stop completely. While these retries curr_mark_cnt can be small- especially on HDD drives, so subtraction result can be smaller than 0. However it is casted to uint without checking. As a result of it the status bar in /proc/mdstat while stopping is strange (it jumps between 0% and 99%).
The real problem occurs here after commit 72deb455b5ec ("block: remove CONFIG_LBDAF"). Sector_div() macro has been changed, now the divisor is casted to uint32. For db = -8 the divisior(db/32-1) becomes 0.
Check if db value can be really counted and replace these macro by div64_u64() inline.
Signed-off-by: Mariusz Tkaczyk mariusz.tkaczyk@intel.com Signed-off-by: Song Liu songliubraving@fb.com Signed-off-by: Sasha Levin sashal@kernel.org --- drivers/md/md.c | 36 ++++++++++++++++++++++-------------- 1 file changed, 22 insertions(+), 14 deletions(-)
diff --git a/drivers/md/md.c b/drivers/md/md.c index 295ff09cff4c..84aec3647994 100644 --- a/drivers/md/md.c +++ b/drivers/md/md.c @@ -7617,9 +7617,9 @@ static void status_unused(struct seq_file *seq) static int status_resync(struct seq_file *seq, struct mddev *mddev) { sector_t max_sectors, resync, res; - unsigned long dt, db; - sector_t rt; - int scale; + unsigned long dt, db = 0; + sector_t rt, curr_mark_cnt, resync_mark_cnt; + int scale, recovery_active; unsigned int per_milli;
if (test_bit(MD_RECOVERY_SYNC, &mddev->recovery) || @@ -7708,22 +7708,30 @@ static int status_resync(struct seq_file *seq, struct mddev *mddev) * db: blocks written from mark until now * rt: remaining time * - * rt is a sector_t, so could be 32bit or 64bit. - * So we divide before multiply in case it is 32bit and close - * to the limit. - * We scale the divisor (db) by 32 to avoid losing precision - * near the end of resync when the number of remaining sectors - * is close to 'db'. - * We then divide rt by 32 after multiplying by db to compensate. - * The '+1' avoids division by zero if db is very small. + * rt is a sector_t, which is always 64bit now. We are keeping + * the original algorithm, but it is not really necessary. + * + * Original algorithm: + * So we divide before multiply in case it is 32bit and close + * to the limit. + * We scale the divisor (db) by 32 to avoid losing precision + * near the end of resync when the number of remaining sectors + * is close to 'db'. + * We then divide rt by 32 after multiplying by db to compensate. + * The '+1' avoids division by zero if db is very small. */ dt = ((jiffies - mddev->resync_mark) / HZ); if (!dt) dt++; - db = (mddev->curr_mark_cnt - atomic_read(&mddev->recovery_active)) - - mddev->resync_mark_cnt; + + curr_mark_cnt = mddev->curr_mark_cnt; + recovery_active = atomic_read(&mddev->recovery_active); + resync_mark_cnt = mddev->resync_mark_cnt; + + if (curr_mark_cnt >= (recovery_active + resync_mark_cnt)) + db = curr_mark_cnt - (recovery_active + resync_mark_cnt);
rt = max_sectors - resync; /* number of remaining sectors */ - sector_div(rt, db/32+1); + rt = div64_u64(rt, db/32+1); rt *= dt; rt >>= 5;