Hello Paul,
On Tue, Nov 29, 2022 at 12:25:56PM +0000, Paul Cercueil wrote:
Hi Uwe,
Le lun. 28 nov. 2022 à 15:39:11 +0100, Uwe Kleine-König u.kleine-koenig@pengutronix.de a écrit :
Hello,
On Tue, Oct 25, 2022 at 11:10:46AM +0100, Paul Cercueil wrote:
Note that for disabled PWMs there is no official guaranty about the pin state. So it would be ok (but admittedly not great) to simplify the driver and accept that the pinstate is active while the PWM is off. IMHO this is also better than a glitch.
If a consumer wants the PWM to be in its inactive state, they should not disable it.
Completely disagree. I absolutely do not want the backlight to go full bright mode when the PWM pin is disabled. And disabling the backlight is a thing (for screen blanking and during mode changes).
For some hardwares there is no pretty choice. So the gist is: If the backlight driver wants to ensure that the PWM pin is driven to its inactive level, it should use:
pwm_apply(pwm, { .period = ..., .duty_cycle = 0, .enabled = true });
and better not
pwm_apply(pwm, { ..., .enabled = false });
Well that sounds pretty stupid to me; why doesn't the PWM subsystem enforce that the pins must be driven to their inactive level when the PWM function is disabled?
Then for such hardware you describe, the corresponding PWM driver could itself apply a duty_cycle = 0 if that's what it takes to get an inactive state.
Let's assume we claim that on disable the pin is driven to the inactive level.
The (bad) effect is that for a use case where the pin state doesn't matter (e.g. a backlight where the power regulator is off), the PWM keeps running even though it could be disabled and so save some power.
So to make this use case properly supported, we need another flag in struct pwm_state that allows the consumer to tell the lowlevel driver that it's ok to disable the hardware even with the output being UB. Let's call this new flag "spam" and the pin is allowed to do whatever it wants with .spam = false.
After that you can realize that applying any state with:
.duty_cycle = A, .period = B, .polarity = C, .enabled = false, .spam = true,
semantically (i.e. just looking at the output) has the same effect as
.duty_cycle = 0, .period = $something, .polarity = C, .enabled = true, .spam = true,
So having .enabled doesn't add to the expressiveness of pwm_apply(), because you can specify any configuration without having to resort to .enabled = false. So the enabled member of struct pwm_state can be dropped.
Then we end up with the exact scenario we have now, just that the flag that specifies if the output should be held in the inactive state has a bad name.
Best regards Uwe