From: Horatiu Vultur horatiu.vultur@microchip.com
[ Upstream commit d717f9474e3fb7e6bd3e43ca16e131f04320ed6f ]
When the PCS was taken out of reset, we were changing by mistake also the speed to 100 Mbit. But in case the link was going down, the link up routine was setting correctly the link speed. If the link was not getting down then the speed was forced to run at 100 even if the speed was something else. On lan966x, to set the speed link to 1G or 2.5G a value of 1 needs to be written in DEV_CLOCK_CFG_LINK_SPEED. This is similar to the procedure in lan966x_port_init.
The issue was reproduced using 1000base-x sfp module using the commands: ip link set dev eth2 up ip link addr add 10.97.10.2/24 dev eth2 ethtool -s eth2 speed 1000 autoneg off
Fixes: d28d6d2e37d1 ("net: lan966x: add port module support") Signed-off-by: Horatiu Vultur horatiu.vultur@microchip.com Reviewed-by: Piotr Raczynski piotr.raczynski@intel.com Link: https://lore.kernel.org/r/20221221093315.939133-1-horatiu.vultur@microchip.c... Signed-off-by: Paolo Abeni pabeni@redhat.com Signed-off-by: Sasha Levin sashal@kernel.org --- drivers/net/ethernet/microchip/lan966x/lan966x_port.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/net/ethernet/microchip/lan966x/lan966x_port.c b/drivers/net/ethernet/microchip/lan966x/lan966x_port.c index 1a61c6cdb077..0050fcb988b7 100644 --- a/drivers/net/ethernet/microchip/lan966x/lan966x_port.c +++ b/drivers/net/ethernet/microchip/lan966x/lan966x_port.c @@ -381,7 +381,7 @@ int lan966x_port_pcs_set(struct lan966x_port *port, }
/* Take PCS out of reset */ - lan_rmw(DEV_CLOCK_CFG_LINK_SPEED_SET(2) | + lan_rmw(DEV_CLOCK_CFG_LINK_SPEED_SET(LAN966X_SPEED_1000) | DEV_CLOCK_CFG_PCS_RX_RST_SET(0) | DEV_CLOCK_CFG_PCS_TX_RST_SET(0), DEV_CLOCK_CFG_LINK_SPEED |