From: chihhao.chen chihhao.chen@mediatek.com
[ Upstream commit 4511781f95da0a3b2bad34f3f5e3967e80cd2d18 ]
The following scenario describes an echo test for Samsung USBC Headset (AKG) with VID/PID (0x04e8/0xa051).
We first start a capture stream(USB IN transfer) in 96Khz/24bit/1ch mode. In clock find source function, we get value 0x2 for clock selector and 0x1 for clock source.
Kernel-4.14 behavior Since clock source is valid so clock selector was not set again. We pass through this function and start a playback stream(USB OUT transfer) in 48Khz/32bit/2ch mode. This time we get value 0x1 for clock selector and 0x1 for clock source. Finally clock id with this setting is 0x9.
Kernel-5.10 behavior Clock selector was always set one more time even it is valid. When we start a playback stream, we will get 0x2 for clock selector and 0x1 for clock source. In this case clock id becomes 0xA. This is an incorrect clock source setting and results in severe noises. We see wrong data rate in USB IN transfer. (From 288 bytes/ms becomes 144 bytes/ms) It should keep in 288 bytes/ms.
This earphone works fine on older kernel version load because this is a newly-added behavior.
Fixes: d2e8f641257d ("ALSA: usb-audio: Explicitly set up the clock selector") Signed-off-by: chihhao.chen chihhao.chen@mediatek.com Link: https://lore.kernel.org/r/1627100621-19225-1-git-send-email-chihhao.chen@med... Signed-off-by: Takashi Iwai tiwai@suse.de Signed-off-by: Sasha Levin sashal@kernel.org --- sound/usb/clock.c | 6 ++++++ 1 file changed, 6 insertions(+)
diff --git a/sound/usb/clock.c b/sound/usb/clock.c index 863ac42076e5..d1455fb2c6fc 100644 --- a/sound/usb/clock.c +++ b/sound/usb/clock.c @@ -296,6 +296,12 @@ static int __uac_clock_find_source(struct snd_usb_audio *chip, selector->baCSourceID[ret - 1], visited, validate); if (ret > 0) { + /* + * For Samsung USBC Headset (AKG), setting clock selector again + * will result in incorrect default clock setting problems + */ + if (chip->usb_id == USB_ID(0x04e8, 0xa051)) + return ret; err = uac_clock_selector_set_val(chip, entity_id, cur); if (err < 0) return err;