From: Russell King rmk+kernel@armlinux.org.uk
[ Upstream commit 2cc0bfc9c12784188482a8f3d751d44af45b0d97 ]
The PHY address bit 2 is configured by the LED pin. Attaching a LED to this pin is not sufficient to guarantee this configuration pin is correctly read. This leads to some platforms having their PHY at address 0 and others at address 4.
If there is no phy-handle specified, the FEC driver will scan the PHY bus for a PHY and use that. Consequently, adding the DT configuration of the PHY and the phy properties to the FEC driver broke some boards.
Fix this by removing the phy-handle property, and listing two PHY entries for both possible PHY addresses, so that the DT configuration for the PHY can be found by the PHY driver.
Fixes: 86b08bd5b994 ("ARM: dts: imx6-sr-som: add ethernet PHY configuration") Reported-by: Christoph Mattheis christoph.mattheis@arcor.de Signed-off-by: Russell King rmk+kernel@armlinux.org.uk Signed-off-by: Shawn Guo shawnguo@kernel.org Signed-off-by: Sasha Levin sashal@kernel.org --- arch/arm/boot/dts/imx6qdl-sr-som.dtsi | 12 ++++++++++-- 1 file changed, 10 insertions(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/imx6qdl-sr-som.dtsi b/arch/arm/boot/dts/imx6qdl-sr-som.dtsi index b06577808ff4e..7e4e5fd0143a1 100644 --- a/arch/arm/boot/dts/imx6qdl-sr-som.dtsi +++ b/arch/arm/boot/dts/imx6qdl-sr-som.dtsi @@ -53,7 +53,6 @@ &fec { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_microsom_enet_ar8035>; - phy-handle = <&phy>; phy-mode = "rgmii-id"; phy-reset-duration = <2>; phy-reset-gpios = <&gpio4 15 GPIO_ACTIVE_LOW>; @@ -63,10 +62,19 @@ #address-cells = <1>; #size-cells = <0>;
- phy: ethernet-phy@0 { + /* + * The PHY can appear at either address 0 or 4 due to the + * configuration (LED) pin not being pulled sufficiently. + */ + ethernet-phy@0 { reg = <0>; qca,clk-out-frequency = <125000000>; }; + + ethernet-phy@4 { + reg = <4>; + qca,clk-out-frequency = <125000000>; + }; }; };