From: Michal Vokáč michal.vokac@ysoft.com
commit 0e4a4a08cd78efcaddbc2e4c5ed86b5a5cb8a15e upstream.
The FEC does not have a PHY so it should not have a phy-handle. It is connected to the switch at RGMII level so we need a fixed-link sub-node on both ends.
This was not a problem until the qca8k.c driver was converted to PHYLINK by commit b3591c2a3661 ("net: dsa: qca8k: Switch to PHYLINK instead of PHYLIB"). That commit revealed the FEC configuration was not correct.
Fixes: 87489ec3a77f ("ARM: dts: imx: Add Y Soft IOTA Draco, Hydra and Ursa boards") Cc: stable@vger.kernel.org Signed-off-by: Michal Vokáč michal.vokac@ysoft.com Reviewed-by: Andrew Lunn andrew@lunn.ch Signed-off-by: Shawn Guo shawnguo@kernel.org Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org --- arch/arm/boot/dts/imx6dl-yapp4-common.dtsi | 6 +++++- 1 file changed, 5 insertions(+), 1 deletion(-)
--- a/arch/arm/boot/dts/imx6dl-yapp4-common.dtsi +++ b/arch/arm/boot/dts/imx6dl-yapp4-common.dtsi @@ -105,9 +105,13 @@ phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>; phy-reset-duration = <20>; phy-supply = <&sw2_reg>; - phy-handle = <ðphy0>; status = "okay";
+ fixed-link { + speed = <1000>; + full-duplex; + }; + mdio { #address-cells = <1>; #size-cells = <0>;