UCSI specification quite clearly states that if a command can't be completed in 10ms, the firmware must notify about BUSY condition. Unfortunately almost none of the platforms (the firmware on them) generate the BUSY notification even if a command can't be completed in time.
The driver already considered that, and used a timeout value of 5 seconds, but processing especially the alternate mode discovery commands takes often considerable amount of time from the firmware, much more than the 5 seconds. That happens especially after bootup when devices are already connected to the USB Type-C connector. For now on those platforms the alternate mode discovery has simply failed because of the timeout.
To improve the situation, increasing the timeout value for the command completion to 1 minute. That should give enough time for even the slowest firmware to process the commands.
Fixes: f56de278e8ec ("usb: typec: ucsi: acpi: Move to the new API") Cc: stable@vger.kernel.org Signed-off-by: Heikki Krogerus heikki.krogerus@linux.intel.com --- drivers/usb/typec/ucsi/ucsi_acpi.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/usb/typec/ucsi/ucsi_acpi.c b/drivers/usb/typec/ucsi/ucsi_acpi.c index c0aca2f0f23f0..fbfe8f5933af8 100644 --- a/drivers/usb/typec/ucsi/ucsi_acpi.c +++ b/drivers/usb/typec/ucsi/ucsi_acpi.c @@ -78,7 +78,7 @@ static int ucsi_acpi_sync_write(struct ucsi *ucsi, unsigned int offset, if (ret) goto out_clear_bit;
- if (!wait_for_completion_timeout(&ua->complete, msecs_to_jiffies(5000))) + if (!wait_for_completion_timeout(&ua->complete, 60 * HZ)) ret = -ETIMEDOUT;
out_clear_bit: