6.1-stable review patch. If anyone has any objections, please let me know.
------------------
From: Steve Wilkins steve.wilkins@raymarine.com
[ Upstream commit 3a5e76283672efddf47cea39ccfe9f5735cc91d5 ]
mchp_corespi_init() reads the CONTROL register, sets the master and motorola bits, but doesn't write the value back to the register. The function also doesn't ensure the controller is disabled at the start, which may present a problem if the controller was used by an earlier boot stage as some settings (including the mode) can only be modified while the controller is disabled.
Fixes: 9ac8d17694b6 ("spi: add support for microchip fpga spi controllers") Signed-off-by: Steve Wilkins steve.wilkins@raymarine.com Signed-off-by: Conor Dooley conor.dooley@microchip.com Link: https://patch.msgid.link/20240715-designing-thus-05f7c26e1da7@wendy Signed-off-by: Mark Brown broonie@kernel.org Signed-off-by: Sasha Levin sashal@kernel.org --- drivers/spi/spi-microchip-core.c | 17 +++++++++-------- 1 file changed, 9 insertions(+), 8 deletions(-)
diff --git a/drivers/spi/spi-microchip-core.c b/drivers/spi/spi-microchip-core.c index a5173d820ac2e..bfad0fe743ad7 100644 --- a/drivers/spi/spi-microchip-core.c +++ b/drivers/spi/spi-microchip-core.c @@ -289,17 +289,13 @@ static void mchp_corespi_init(struct spi_controller *host, struct mchp_corespi * unsigned long clk_hz; u32 control = mchp_corespi_read(spi, REG_CONTROL);
- control |= CONTROL_MASTER; + control &= ~CONTROL_ENABLE; + mchp_corespi_write(spi, REG_CONTROL, control);
+ control |= CONTROL_MASTER; control &= ~CONTROL_MODE_MASK; control |= MOTOROLA_MODE;
- mchp_corespi_set_framesize(spi, DEFAULT_FRAMESIZE); - - /* max. possible spi clock rate is the apb clock rate */ - clk_hz = clk_get_rate(spi->clk); - host->max_speed_hz = clk_hz; - /* * The controller must be configured so that it doesn't remove Chip * Select until the entire message has been transferred, even if at @@ -308,11 +304,16 @@ static void mchp_corespi_init(struct spi_controller *host, struct mchp_corespi * * BIGFIFO mode is also enabled, which sets the fifo depth to 32 frames * for the 8 bit transfers that this driver uses. */ - control = mchp_corespi_read(spi, REG_CONTROL); control |= CONTROL_SPS | CONTROL_BIGFIFO;
mchp_corespi_write(spi, REG_CONTROL, control);
+ mchp_corespi_set_framesize(spi, DEFAULT_FRAMESIZE); + + /* max. possible spi clock rate is the apb clock rate */ + clk_hz = clk_get_rate(spi->clk); + host->max_speed_hz = clk_hz; + mchp_corespi_enable_ints(spi);
/*