The current logic is enabling both STOP_INT_MASK and ABORT_INT_MASK bit. This is apparently masking those particular interrupts rather than unmasking the same. If the interrupts are masked, they would never get triggered.
So fix the issue by unmasking the STOP and ABORT interrupts properly.
Fixes: e74c39573d35 ("dmaengine: dw-edma: Add support for native HDMA") cc: stable@vger.kernel.org Signed-off-by: Mrinmay Sarkar quic_msarkar@quicinc.com --- drivers/dma/dw-edma/dw-hdma-v0-core.c | 9 +++++---- 1 file changed, 5 insertions(+), 4 deletions(-)
diff --git a/drivers/dma/dw-edma/dw-hdma-v0-core.c b/drivers/dma/dw-edma/dw-hdma-v0-core.c index 10e8f07..fa89b3a 100644 --- a/drivers/dma/dw-edma/dw-hdma-v0-core.c +++ b/drivers/dma/dw-edma/dw-hdma-v0-core.c @@ -247,10 +247,11 @@ static void dw_hdma_v0_core_start(struct dw_edma_chunk *chunk, bool first) if (first) { /* Enable engine */ SET_CH_32(dw, chan->dir, chan->id, ch_en, BIT(0)); - /* Interrupt enable&unmask - done, abort */ - tmp = GET_CH_32(dw, chan->dir, chan->id, int_setup) | - HDMA_V0_STOP_INT_MASK | HDMA_V0_ABORT_INT_MASK | - HDMA_V0_LOCAL_STOP_INT_EN | HDMA_V0_LOCAL_ABORT_INT_EN; + /* Interrupt unmask - STOP, ABORT */ + tmp = GET_CH_32(dw, chan->dir, chan->id, int_setup) & + ~HDMA_V0_STOP_INT_MASK & ~HDMA_V0_ABORT_INT_MASK; + /* Interrupt enable - STOP, ABORT */ + tmp |= HDMA_V0_LOCAL_STOP_INT_EN | HDMA_V0_LOCAL_ABORT_INT_EN; if (!(dw->chip->flags & DW_EDMA_CHIP_LOCAL)) tmp |= HDMA_V0_REMOTE_STOP_INT_EN | HDMA_V0_REMOTE_ABORT_INT_EN; SET_CH_32(dw, chan->dir, chan->id, int_setup, tmp);