6.1-stable review patch. If anyone has any objections, please let me know.
------------------
From: Marek Vasut marex@denx.de
[ Upstream commit a210df337c5f5c2cd82f36c9dbb154ec63365c80 ]
The initial state of RESETB input signal of OV5640 should be asserted, i.e. the sensor should be in reset. This is not the case, make it so.
Since the subsequent assertion of RESETB signal is no longer necessary and the timing of the power sequencing could be slightly adjusted, add annotations to the delays which match OV5640 datasheet rev. 2.03, both: figure 2-3 power up timing with internal DVDD figure 2-4 power up timing with external DVDD source
The 5..10ms delay between PWDN assertion and RESETB assertion is not even documented in the power sequencing diagram, and with this reset fix, it is no longer even necessary.
Fixes: 19a81c1426c1 ("[media] add Omnivision OV5640 sensor driver") Reported-by: Jacopo Mondi jacopo.mondi@ideasonboard.com Signed-off-by: Marek Vasut marex@denx.de Reviewed-by: Jacopo Mondi jacopo.mondi@ideasonboard.com Tested-by: Jai Luthra j-luthra@ti.com Signed-off-by: Sakari Ailus sakari.ailus@linux.intel.com Signed-off-by: Mauro Carvalho Chehab mchehab@kernel.org Signed-off-by: Sasha Levin sashal@kernel.org --- drivers/media/i2c/ov5640.c | 11 ++++------- 1 file changed, 4 insertions(+), 7 deletions(-)
diff --git a/drivers/media/i2c/ov5640.c b/drivers/media/i2c/ov5640.c index f76bcb395cffa..2ee832426736d 100644 --- a/drivers/media/i2c/ov5640.c +++ b/drivers/media/i2c/ov5640.c @@ -2441,16 +2441,13 @@ static void ov5640_power(struct ov5640_dev *sensor, bool enable) static void ov5640_powerup_sequence(struct ov5640_dev *sensor) { if (sensor->pwdn_gpio) { - gpiod_set_value_cansleep(sensor->reset_gpio, 0); + gpiod_set_value_cansleep(sensor->reset_gpio, 1);
/* camera power cycle */ ov5640_power(sensor, false); - usleep_range(5000, 10000); + usleep_range(5000, 10000); /* t2 */ ov5640_power(sensor, true); - usleep_range(5000, 10000); - - gpiod_set_value_cansleep(sensor->reset_gpio, 1); - usleep_range(1000, 2000); + usleep_range(1000, 2000); /* t3 */
gpiod_set_value_cansleep(sensor->reset_gpio, 0); } else { @@ -2458,7 +2455,7 @@ static void ov5640_powerup_sequence(struct ov5640_dev *sensor) ov5640_write_reg(sensor, OV5640_REG_SYS_CTRL0, OV5640_REG_SYS_CTRL0_SW_RST); } - usleep_range(20000, 25000); + usleep_range(20000, 25000); /* t4 */
/* * software standby: allows registers programming;