From: Grygorii Strashko grygorii.strashko@ti.com
[ Upstream commit 5a7f08c2abb0efc9d17aff2fc75d6d3b85e622e4 ]
The link detection timeouts can be observed (or link might not be detected at all) when dp83867 PHY is configured in manual mode (speed/duplex).
CFG3[9] Robust Auto-MDIX option allows to significantly improve link detection in case dp83867 is configured in manual mode and reduce link detection time. As per DM: "If link partners are configured to operational modes that are not supported by normal Auto MDI/MDIX mode (like Auto-Neg versus Force 100Base-TX or Force 100Base-TX versus Force 100Base-TX), this Robust Auto MDI/MDIX mode allows MDI/MDIX resolution and prevents deadlock."
Hence, enable this option by default as there are no known reasons not to do so.
Signed-off-by: Grygorii Strashko grygorii.strashko@ti.com Reviewed-by: Andrew Lunn andrew@lunn.ch Reviewed-by: Florian Fainelli f.fainelli@gmail.com Signed-off-by: David S. Miller davem@davemloft.net Signed-off-by: Sasha Levin sashal@kernel.org --- drivers/net/phy/dp83867.c | 15 ++++++++++----- 1 file changed, 10 insertions(+), 5 deletions(-)
diff --git a/drivers/net/phy/dp83867.c b/drivers/net/phy/dp83867.c index e03e91d5f1b1b..0cbcced0870e6 100644 --- a/drivers/net/phy/dp83867.c +++ b/drivers/net/phy/dp83867.c @@ -84,6 +84,10 @@ #define DP83867_IO_MUX_CFG_IO_IMPEDANCE_MAX 0x0 #define DP83867_IO_MUX_CFG_IO_IMPEDANCE_MIN 0x1f
+/* CFG3 bits */ +#define DP83867_CFG3_INT_OE BIT(7) +#define DP83867_CFG3_ROBUST_AUTO_MDIX BIT(9) + /* CFG4 bits */ #define DP83867_CFG4_PORT_MIRROR_EN BIT(0)
@@ -320,12 +324,13 @@ static int dp83867_config_init(struct phy_device *phydev) return ret; }
+ val = phy_read(phydev, DP83867_CFG3); /* Enable Interrupt output INT_OE in CFG3 register */ - if (phy_interrupt_is_valid(phydev)) { - val = phy_read(phydev, DP83867_CFG3); - val |= BIT(7); - phy_write(phydev, DP83867_CFG3, val); - } + if (phy_interrupt_is_valid(phydev)) + val |= DP83867_CFG3_INT_OE; + + val |= DP83867_CFG3_ROBUST_AUTO_MDIX; + phy_write(phydev, DP83867_CFG3, val);
if (dp83867->port_mirroring != DP83867_PORT_MIRROING_KEEP) dp83867_config_port_mirroring(phydev);