From: Wen Gong quic_wgong@quicinc.com
[ Upstream commit f74878433d5ade360447da5d92e9c2e535780d80 ]
Commit 26f3a021b37c ("ath11k: allocate smaller chunks of memory for firmware") and commit f6f92968e1e5 ("ath11k: qmi: try to allocate a big block of DMA memory first") change ath11k to allocate the memory chunks for target twice while wlan load. It fails for the 1st time because of large memory and then changed to allocate many small chunks for the 2nd time sometimes as below log.
1st time failed: [10411.640620] ath11k_pci 0000:05:00.0: qmi firmware request memory request [10411.640625] ath11k_pci 0000:05:00.0: qmi mem seg type 1 size 6881280 [10411.640630] ath11k_pci 0000:05:00.0: qmi mem seg type 4 size 3784704 [10411.640658] ath11k_pci 0000:05:00.0: qmi dma allocation failed (6881280 B type 1), will try later with small size [10411.640671] ath11k_pci 0000:05:00.0: qmi delays mem_request 2 [10411.640677] ath11k_pci 0000:05:00.0: qmi respond memory request delayed 1 2nd time success: [10411.642004] ath11k_pci 0000:05:00.0: qmi firmware request memory request [10411.642008] ath11k_pci 0000:05:00.0: qmi mem seg type 1 size 524288 [10411.642012] ath11k_pci 0000:05:00.0: qmi mem seg type 1 size 524288 [10411.642014] ath11k_pci 0000:05:00.0: qmi mem seg type 1 size 524288 [10411.642016] ath11k_pci 0000:05:00.0: qmi mem seg type 1 size 524288 [10411.642018] ath11k_pci 0000:05:00.0: qmi mem seg type 1 size 524288 [10411.642020] ath11k_pci 0000:05:00.0: qmi mem seg type 1 size 524288 [10411.642022] ath11k_pci 0000:05:00.0: qmi mem seg type 1 size 524288 [10411.642024] ath11k_pci 0000:05:00.0: qmi mem seg type 1 size 524288 [10411.642027] ath11k_pci 0000:05:00.0: qmi mem seg type 1 size 524288 [10411.642029] ath11k_pci 0000:05:00.0: qmi mem seg type 1 size 524288 [10411.642031] ath11k_pci 0000:05:00.0: qmi mem seg type 1 size 458752 [10411.642033] ath11k_pci 0000:05:00.0: qmi mem seg type 1 size 131072 [10411.642035] ath11k_pci 0000:05:00.0: qmi mem seg type 4 size 524288 [10411.642037] ath11k_pci 0000:05:00.0: qmi mem seg type 4 size 524288 [10411.642039] ath11k_pci 0000:05:00.0: qmi mem seg type 4 size 524288 [10411.642041] ath11k_pci 0000:05:00.0: qmi mem seg type 4 size 524288 [10411.642043] ath11k_pci 0000:05:00.0: qmi mem seg type 4 size 524288 [10411.642045] ath11k_pci 0000:05:00.0: qmi mem seg type 4 size 524288 [10411.642047] ath11k_pci 0000:05:00.0: qmi mem seg type 4 size 491520 [10411.642049] ath11k_pci 0000:05:00.0: qmi mem seg type 1 size 524288
And then commit 5962f370ce41 ("ath11k: Reuse the available memory after firmware reload") skip the ath11k_qmi_free_resource() which frees the memory chunks while recovery, after that, when run recovery test on WCN6855, a warning happened every time as below and finally leads fail for recovery.
[ 159.570318] BUG: Bad page state in process kworker/u16:5 pfn:33300 [ 159.570320] page:0000000096ffdbb9 refcount:1 mapcount:0 mapping:0000000000000000 index:0x0 pfn:0x33300 [ 159.570324] flags: 0xfffffc0000000(node=0|zone=1|lastcpupid=0x1fffff) [ 159.570329] raw: 000fffffc0000000 0000000000000000 dead000000000122 0000000000000000 [ 159.570332] raw: 0000000000000000 0000000000000000 00000001ffffffff 0000000000000000 [ 159.570334] page dumped because: nonzero _refcount [ 159.570440] firewire_ohci syscopyarea sysfillrect psmouse sdhci_pci ahci sysimgblt firewire_core fb_sys_fops libahci crc_itu_t cqhci drm sdhci e1000e wmi video [ 159.570460] CPU: 2 PID: 217 Comm: kworker/u16:5 Kdump: loaded Tainted: G B 5.19.0-rc1-wt-ath+ #3 [ 159.570465] Hardware name: LENOVO 418065C/418065C, BIOS 83ET63WW (1.33 ) 07/29/2011 [ 159.570467] Workqueue: qmi_msg_handler qmi_data_ready_work [qmi_helpers] [ 159.570475] Call Trace: [ 159.570476] <TASK> [ 159.570478] dump_stack_lvl+0x49/0x5f [ 159.570486] dump_stack+0x10/0x12 [ 159.570493] bad_page+0xab/0xf0 [ 159.570502] check_free_page_bad+0x66/0x70 [ 159.570511] __free_pages_ok+0x530/0x9a0 [ 159.570517] ? __dev_printk+0x58/0x6b [ 159.570525] ? _dev_printk+0x56/0x72 [ 159.570534] ? qmi_decode+0x119/0x470 [qmi_helpers] [ 159.570543] __free_pages+0x91/0xd0 [ 159.570548] dma_free_contiguous+0x50/0x60 [ 159.570556] dma_direct_free+0xe5/0x140 [ 159.570564] dma_free_attrs+0x35/0x50 [ 159.570570] ath11k_qmi_msg_mem_request_cb+0x2ae/0x3c0 [ath11k] [ 159.570620] qmi_invoke_handler+0xac/0xe0 [qmi_helpers] [ 159.570630] qmi_handle_message+0x6d/0x180 [qmi_helpers] [ 159.570643] qmi_data_ready_work+0x2ca/0x440 [qmi_helpers] [ 159.570656] process_one_work+0x227/0x440 [ 159.570667] worker_thread+0x31/0x3d0 [ 159.570676] ? process_one_work+0x440/0x440 [ 159.570685] kthread+0xfe/0x130 [ 159.570692] ? kthread_complete_and_exit+0x20/0x20 [ 159.570701] ret_from_fork+0x22/0x30 [ 159.570712] </TASK>
The reason is because when wlan start to recovery, the type, size and count is not same for the 1st and 2nd QMI_WLFW_REQUEST_MEM_IND message, Then it leads the parameter size is not correct for the dma_free_coherent(). For the chunk[1], the actual dma size is 524288 which allocate in the 2nd time of the initial wlan load phase, and the size which pass to dma_free_coherent() is 3784704 which is got in the 1st time of recovery phase, then warning above happened.
Change to use prev_size of struct target_mem_chunk for the paramter of dma_free_coherent() since prev_size is the real size of last load/recovery. Also change to check both type and size of struct target_mem_chunk to reuse the memory to avoid mismatch buffer size for target. Then the warning disappear and recovery success. When the 1st QMI_WLFW_REQUEST_MEM_IND for recovery arrived, the trunk[0] is freed in ath11k_qmi_alloc_target_mem_chunk() and then dma_alloc_coherent() failed caused by large size, and then trunk[1] is freed in ath11k_qmi_free_target_mem_chunk(), the left 18 trunks will be reuse for the 2nd QMI_WLFW_REQUEST_MEM_IND message.
Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-03125-QCAHSPSWPL_V1_V2_SILICONZ_LITE-3
Fixes: 5962f370ce41 ("ath11k: Reuse the available memory after firmware reload") Signed-off-by: Wen Gong quic_wgong@quicinc.com Signed-off-by: Kalle Valo quic_kvalo@quicinc.com Link: https://lore.kernel.org/r/20220928073832.16251-1-quic_wgong@quicinc.com Signed-off-by: Sasha Levin sashal@kernel.org --- drivers/net/wireless/ath/ath11k/qmi.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/net/wireless/ath/ath11k/qmi.c b/drivers/net/wireless/ath/ath11k/qmi.c index 7cc5fa3251521..381c6b390dd78 100644 --- a/drivers/net/wireless/ath/ath11k/qmi.c +++ b/drivers/net/wireless/ath/ath11k/qmi.c @@ -1964,7 +1964,7 @@ static void ath11k_qmi_free_target_mem_chunk(struct ath11k_base *ab) continue;
dma_free_coherent(ab->dev, - ab->qmi.target_mem[i].size, + ab->qmi.target_mem[i].prev_size, ab->qmi.target_mem[i].vaddr, ab->qmi.target_mem[i].paddr); ab->qmi.target_mem[i].vaddr = NULL; @@ -1985,12 +1985,12 @@ static int ath11k_qmi_alloc_target_mem_chunk(struct ath11k_base *ab) * in such case, no need to allocate memory for FW again. */ if (chunk->vaddr) { - if (chunk->prev_type == chunk->type || + if (chunk->prev_type == chunk->type && chunk->prev_size == chunk->size) continue;
/* cannot reuse the existing chunk */ - dma_free_coherent(ab->dev, chunk->size, + dma_free_coherent(ab->dev, chunk->prev_size, chunk->vaddr, chunk->paddr); chunk->vaddr = NULL; }