Hi Greg,
On 07/05/2025 19:39, Greg Kroah-Hartman wrote:
This is the start of the stable review cycle for the 5.15.182 release. There are 55 patches in this series, all will be posted as a response to this one. If anyone has any issues with these being applied, please let me know.
Responses should be made by Fri, 09 May 2025 18:37:41 +0000. Anything received after that time might be too late.
The whole patch series can be found in one patch at: https://www.kernel.org/pub/linux/kernel/v5.x/stable-review/patch-5.15.182-rc... or in the git tree and branch at: git://git.kernel.org/pub/scm/linux/kernel/git/stable/linux-stable-rc.git linux-5.15.y and the diffstat can be found below.
thanks,
greg k-h
Pseudo-Shortlog of commits:
...
Stephan Gerhold stephan.gerhold@linaro.org serial: msm: Configure correct working mode before starting earlycon
The above commit is breaking the build for ARM64 and I am seeing the following build error ...
drivers/tty/serial/msm_serial.c: In function ‘msm_serial_early_console_setup_dm’: drivers/tty/serial/msm_serial.c:1737:34: error: ‘MSM_UART_CR_CMD_RESET_RX’ undeclared (first use in this function); did you mean ‘UART_CR_CMD_RESET_RX’? 1737 | msm_write(&device->port, MSM_UART_CR_CMD_RESET_RX, MSM_UART_CR); | ^~~~~~~~~~~~~~~~~~~~~~~~ | UART_CR_CMD_RESET_RX drivers/tty/serial/msm_serial.c:1737:34: note: each undeclared identifier is reported only once for each function it appears in drivers/tty/serial/msm_serial.c:1737:60: error: ‘MSM_UART_CR’ undeclared (first use in this function); did you mean ‘UART_CR’? 1737 | msm_write(&device->port, MSM_UART_CR_CMD_RESET_RX, MSM_UART_CR); | ^~~~~~~~~~~ | UART_CR drivers/tty/serial/msm_serial.c:1738:34: error: ‘MSM_UART_CR_CMD_RESET_TX’ undeclared (first use in this function); did you mean ‘UART_CR_CMD_RESET_TX’? 1738 | msm_write(&device->port, MSM_UART_CR_CMD_RESET_TX, MSM_UART_CR); | ^~~~~~~~~~~~~~~~~~~~~~~~ | UART_CR_CMD_RESET_TX CC drivers/ata/libata-transport.o drivers/tty/serial/msm_serial.c:1739:34: error: ‘MSM_UART_CR_TX_ENABLE’ undeclared (first use in this function); did you mean ‘UART_CR_TX_ENABLE’? 1739 | msm_write(&device->port, MSM_UART_CR_TX_ENABLE, MSM_UART_CR); | ^~~~~~~~~~~~~~~~~~~~~ | UART_CR_TX_ENABLE
After reverting this, the build is passing again.
Thanks! Jon