From: Martin Blumenstingl martin.blumenstingl@googlemail.com
[ Upstream commit e56088a13708757da68ad035269d69b93ac8c389 ]
The public datasheets of the following Amlogic SoCs describe a typical resistor value for the built-in pull up/down resistor: - Meson8/8b/8m2: not documented - GXBB (S905): 60 kOhm - GXL (S905X): 60 kOhm - GXM (S912): 60 kOhm - G12B (S922X): 60 kOhm - SM1 (S905D3): 60 kOhm
The public G12B and SM1 datasheets additionally state min and max values: - min value: 50 kOhm for both, pull-up and pull-down - max value for the pull-up: 70 kOhm - max value for the pull-down: 130 kOhm
Use 60 kOhm in the pinctrl-meson driver as well so it's shown in the debugfs output. It may not be accurate for Meson8/8b/8m2 but in reality 60 kOhm is closer to the actual value than 1 Ohm.
Signed-off-by: Martin Blumenstingl martin.blumenstingl@googlemail.com Reviewed-by: Neil Armstrong neil.armstrong@linaro.org Link: https://lore.kernel.org/20250329190132.855196-1-martin.blumenstingl@googlema... Signed-off-by: Linus Walleij linus.walleij@linaro.org Signed-off-by: Sasha Levin sashal@kernel.org --- drivers/pinctrl/meson/pinctrl-meson.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/pinctrl/meson/pinctrl-meson.c b/drivers/pinctrl/meson/pinctrl-meson.c index 49851444a6e3b..d239ad85a510d 100644 --- a/drivers/pinctrl/meson/pinctrl-meson.c +++ b/drivers/pinctrl/meson/pinctrl-meson.c @@ -486,7 +486,7 @@ static int meson_pinconf_get(struct pinctrl_dev *pcdev, unsigned int pin, case PIN_CONFIG_BIAS_PULL_DOWN: case PIN_CONFIG_BIAS_PULL_UP: if (meson_pinconf_get_pull(pc, pin) == param) - arg = 1; + arg = 60000; else return -EINVAL; break;