On 11/12/2019 10.44, Marc Kleine-Budde wrote:
On 12/11/19 10:13 AM, Sean Nyekjaer wrote:
When the tcan device comes out of reset it comes out in standby mode. The m_can driver tries to access the control register but fails due to the device is in standby mode. So this patch will put the tcan device in normal mode before the m_can driver does the initialization.
Fixes: a229abeed7f7 ("can: tcan4x5x: Turn on the power before parsing the config") Cc: stable@vger.kernel.org Signed-off-by: Sean Nyekjaer sean@geanix.com
Applied both to linux-can.
Oh, the commit id for "can: tcan4x5x: Turn on the power before parsing the config" have changed, since this morning :)
Ahh, I see.
Until there is a pull request (including a tag) the testing branch is subject to rebase. Meaning, when there is a patch, that needs update I'm happy to squash things into it.
I'm squashing there two commits into one:
It's two different authors :-)
# This is a combination of 2 commits. # This is the 1st commit message:
can: tcan4x5x: Turn on the power before parsing the config
The parse config function now performs action on the device either reading or writing and a reset. If the regulator is managed it needs to be turned on. So turn on the regulator if available if the parsing fails then turn off the regulator.
Fixes: a5235f3c7c23 ("can: tcan45x: Make wake-up GPIO an optional GPIO") Signed-off-by: Dan Murphy dmurphy@ti.com Signed-off-by: Marc Kleine-Budde mkl@pengutronix.de
# This is the commit message #2:
can: tcan4x5x: put the device out of standby before register access
The m_can tries to detect if Non ISO Operation is available while in standby, this function results in the following error:
tcan4x5x spi2.0 (unnamed net_device) (uninitialized): Failed to init module tcan4x5x spi2.0: m_can device registered (irq=84, version=32) tcan4x5x spi2.0 can2: TCAN4X5X successfully initialized.
When the tcan device comes out of reset it comes out in standby mode. The m_can driver tries to access the control register but fails due to the device is in standby mode.
So this patch will put the tcan device in normal mode before the m_can driver does the initialization.
Fixes: a229abeed7f7 ("can: tcan4x5x: Turn on the power before parsing the config") Cc: stable@vger.kernel.org Signed-off-by: Sean Nyekjaer sean@geanix.com Signed-off-by: Marc Kleine-Budde mkl@pengutronix.de
Can you give me an updated commit message?
I think it would be better to update the fixes tag :)
Could update the fixes tag for with the new commit id...
/Sean