On 07/07/2024 15:53, Faizal Rahim wrote:
Following the "igc: Fix TX Hang issue when QBV Gate is close" changes, remaining issues with the reset adapter logic in igc_tsn_offload_apply() have been observed:
- The reset adapter logics for i225 and i226 differ, although they should be the same according to the guidelines in I225/6 HW Design Section 7.5.2.1 on software initialization during tx mode changes.
- The i225 resets adapter every time, even though tx mode doesn't change. This occurs solely based on the condition igc_is_device_id_i225() when calling schedule_work().
- i226 doesn't reset adapter for tsn->legacy tx mode changes. It only resets adapter for legacy->tsn tx mode transitions.
- qbv_count introduced in the patch is actually not needed; in this context, a non-zero value of qbv_count is used to indicate if tx mode was unconditionally set to tsn in igc_tsn_enable_offload(). This could be replaced by checking the existing register IGC_TQAVCTRL_TRANSMIT_MODE_TSN bit.
This patch resolves all issues and enters schedule_work() to reset the adapter only when changing tx mode. It also removes reliance on qbv_count.
qbv_count field will be removed in a future patch.
Test ran:
Verify reset adapter behaviour in i225/6: a) Enrol a new GCL Reset adapter observed (tx mode change legacy->tsn) b) Enrol a new GCL without deleting qdisc No reset adapter observed (tx mode remain tsn->tsn) c) Delete qdisc Reset adapter observed (tx mode change tsn->legacy)
Tested scenario from "igc: Fix TX Hang issue when QBV Gate is closed" to confirm it remains resolved.
Fixes: 175c241288c0 ("igc: Fix TX Hang issue when QBV Gate is closed") Signed-off-by: Faizal Rahim faizal.abdul.rahim@linux.intel.com Reviewed-by: Simon Horman horms@kernel.org Acked-by: Vinicius Costa Gomes vinicius.gomes@intel.com Acked-by: Vinicius Costa Gomes vinicius.gomes@intel.com
drivers/net/ethernet/intel/igc/igc_tsn.c | 23 ++++++++++++++++++++--- 1 file changed, 20 insertions(+), 3 deletions(-)
Tested-by: Mor Bar-Gabay morx.bar.gabay@intel.com