From: Anis Chali chalianis1@gmail.com

from datasheet of dp83869hm 7.3.6 Interrupt The DP83869HM can be configured to generate an interrupt when changes of internal status occur. The interrupt allows a MAC to act upon the status in the PHY without polling the PHY registers. The interrupt source can be selected through the interrupt registers, MICR (12h) and FIBER_INT_EN (C18h). The interrupt status can be read from ISR (13h) and FIBER_INT_STTS (C19h) registers. Some interrupts are enabled by default and can be disabled through register access. Both the interrupt status registers must be read in order to clear pending interrupts. Until the pending interrupts are cleared, new interrupts may not be routed to the interrupt pin. Fixes: interrupts issue when using with an optical fiber sfp.

Signed-off-by: Anis Chali chalianis1@gmail.com --- drivers/net/phy/dp83869.c | 7 +++++++ 1 file changed, 7 insertions(+)

diff --git a/drivers/net/phy/dp83869.c b/drivers/net/phy/dp83869.c index a62cd838a9ea..1e8c20f387b8 100644 --- a/drivers/net/phy/dp83869.c +++ b/drivers/net/phy/dp83869.c @@ -41,6 +41,7 @@ #define DP83869_IO_MUX_CFG 0x0170 #define DP83869_OP_MODE 0x01df #define DP83869_FX_CTRL 0x0c00 +#define DP83869_FX_INT_STS 0x0c19

#define DP83869_SW_RESET BIT(15) #define DP83869_SW_RESTART BIT(14) @@ -195,6 +196,12 @@ static int dp83869_ack_interrupt(struct phy_device *phydev) if (err < 0) return err;

+ if (linkmode_test_bit(ETHTOOL_LINK_MODE_FIBRE_BIT, phydev->supported)) { + err = phy_read_mmd(phydev, DP83869_DEVADDR, DP83869_FX_INT_STS); + if (err < 0) + return err; + } + return 0; }