Hi, Conor

Thanks for your patch.

From: Conor Dooley conor.dooley@microchip.com

Aurelien reported probe failures due to the csi node being enabled without having a camera attached to it. A camera was in the initial submissions, but was removed from the dts, as it had not actually been present on the board, but was from an addon board used by the developer of the relevant drivers. The non-camera pipeline nodes were not disabled when this happened and the probe failures are problematic for Debian. Disable them.

CC: stable@vger.kernel.org Fixes: 28ecaaa5af192 ("riscv: dts: starfive: jh7110: Add camera subsystem nodes")

Here you write it in 13 characters, should be "Fixes: 28ecaaa5af19 ..."

Best Regards Changhuang.

Closes: https://lore.kernel.org/all/Zw1-vcN4CoVkfLjU@aurel32.net/ Reported-by: Aurelien Jarno aurelien@aurel32.net Signed-off-by: Conor Dooley conor.dooley@microchip.com

---

CC: Emil Renner Berthing kernel@esmil.dk CC: Rob Herring robh@kernel.org CC: Krzysztof Kozlowski krzk+dt@kernel.org CC: Conor Dooley conor+dt@kernel.org CC: Changhuang Liang changhuang.liang@starfivetech.com CC: devicetree@vger.kernel.org CC: linux-riscv@lists.infradead.org CC: linux-kernel@vger.kernel.org

---

arch/riscv/boot/dts/starfive/jh7110-common.dtsi | 2 -- 1 file changed, 2 deletions(-)

diff --git a/arch/riscv/boot/dts/starfive/jh7110-common.dtsi b/arch/riscv/boot/dts/starfive/jh7110-common.dtsi index c7771b3b64758..d6c55f1cc96a9 100644 --- a/arch/riscv/boot/dts/starfive/jh7110-common.dtsi +++ b/arch/riscv/boot/dts/starfive/jh7110-common.dtsi @@ -128,7 +128,6 @@ &camss { assigned-clocks = <&ispcrg JH7110_ISPCLK_DOM4_APB_FUNC>, <&ispcrg JH7110_ISPCLK_MIPI_RX0_PXL>; assigned-clock-rates = <49500000>, <198000000>;

• status = "okay";

  ports { #address-cells = <1>;

@@ -151,7 +150,6 @@ camss_from_csi2rx: endpoint { &csi2rx { assigned-clocks = <&ispcrg JH7110_ISPCLK_VIN_SYS>; assigned-clock-rates = <297000000>;

• status = "okay";

  ports { #address-cells = <1>;

-- 2.45.2