Skip this one :)

On 11/12/2019 14.53, Sean Nyekjaer wrote:

The m_can tries to detect if Non ISO Operation is available while in standby, this function results in the following error:

tcan4x5x spi2.0 (unnamed net_device) (uninitialized): Failed to init module tcan4x5x spi2.0: m_can device registered (irq=84, version=32) tcan4x5x spi2.0 can2: TCAN4X5X successfully initialized.

When the tcan device comes out of reset it comes out in standby mode. The m_can driver tries to access the control register but fails due to the device is in standby mode.

So this patch will put the tcan device in normal mode before the m_can driver does the initialization.

Fixes: 5443c226ba91 ("can: tcan4x5x: Add tcan4x5x driver to the kernel") Cc: stable@vger.kernel.org Signed-off-by: Sean Nyekjaer sean@geanix.com Signed-off-by: Marc Kleine-Budde mkl@pengutronix.de

---

Changes since v3:

• added reset if the reset_gpio is not avaliable

Changes since v4:

• added error handling for the SPI I/O

Changes since v5:

• Removed braces for single statement if's

drivers/net/can/m_can/tcan4x5x.c | 4 ++++ 1 file changed, 4 insertions(+)

diff --git a/drivers/net/can/m_can/tcan4x5x.c b/drivers/net/can/m_can/tcan4x5x.c index c1b83dc26c3a..295dbb73c69e 100644 --- a/drivers/net/can/m_can/tcan4x5x.c +++ b/drivers/net/can/m_can/tcan4x5x.c @@ -484,6 +484,10 @@ static int tcan4x5x_can_probe(struct spi_device *spi) if (ret) goto out_power;

• ret = tcan4x5x_init(mcan_class);
• if (ret)

• goto out_power;
  

• ret = m_can_class_register(mcan_class); if (ret) goto out_power;