The Elan eKTH5015M touch controller on the X13s requires a 300 ms delay before sending commands after having deasserted reset during power on.

Switch to the Elan specific binding so that the OS can determine the required power-on sequence and make sure that the controller is always detected during boot.

Note that the always-on 1.8 V supply (s10b) is not used by the controller directly and should not be described.

Fixes: 32c231385ed4 ("arm64: dts: qcom: sc8280xp: add Lenovo Thinkpad X13s devicetree") Cc: stable@vger.kernel.org # 6.0 Tested-by: Steev Klimaszewski steev@kali.org Signed-off-by: Johan Hovold johan+linaro@kernel.org --- .../dts/qcom/sc8280xp-lenovo-thinkpad-x13s.dts | 15 ++++++++------- 1 file changed, 8 insertions(+), 7 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/sc8280xp-lenovo-thinkpad-x13s.dts b/arch/arm64/boot/dts/qcom/sc8280xp-lenovo-thinkpad-x13s.dts index 569add4ebfab..98c1b75513be 100644 --- a/arch/arm64/boot/dts/qcom/sc8280xp-lenovo-thinkpad-x13s.dts +++ b/arch/arm64/boot/dts/qcom/sc8280xp-lenovo-thinkpad-x13s.dts @@ -653,15 +653,16 @@ &i2c4 {

status = "okay";

- /* FIXME: verify */ touchscreen@10 { - compatible = "hid-over-i2c"; + compatible = "elan,ekth5015m", "elan,ekth6915"; reg = <0x10>;

- hid-descr-addr = <0x1>; interrupts-extended = <&tlmm 175 IRQ_TYPE_LEVEL_LOW>; - vdd-supply = <&vreg_misc_3p3>; - vddl-supply = <&vreg_s10b>; + reset-gpios = <&tlmm 99 (GPIO_ACTIVE_LOW | GPIO_OPEN_DRAIN)>; + no-reset-on-power-off; + + vcc33-supply = <&vreg_misc_3p3>; + vccio-supply = <&vreg_misc_3p3>;

pinctrl-names = "default"; pinctrl-0 = <&ts0_default>; @@ -1507,8 +1508,8 @@ int-n-pins { reset-n-pins { pins = "gpio99"; function = "gpio"; - output-high; - drive-strength = <16>; + drive-strength = <2>; + bias-disable; }; };