On Sat, 23 Jun 2018 01:06:34 +0900 Masahiro Yamada yamada.masahiro@socionext.com wrote:

Since commit 1bb88666775e ("mtd: nand: denali: handle timing parameters by setup_data_interface()"), denali_dt.c gets the clock rate from the clock driver. The driver expects the frequency of the bus interface clock, whereas the clock driver of SOCFPGA provides the core clock. Thus, the setup_data_interface() hook calculates timing parameters based on a wrong frequency.

To make it work without relying on the clock driver, hard-code the clock frequency, 200MHz. This is fine for existing DT of UniPhier, and also fixes the issue of SOCFPGA because both platforms use 200 MHz for the bus interface clock.

Fixes: 1bb88666775e ("mtd: nand: denali: handle timing parameters by setup_data_interface()") Cc: linux-stable stable@vger.kernel.org #4.14+ Reported-by: Philipp Rosenberger p.rosenberger@linutronix.de Suggested-by: Boris Brezillon boris.brezillon@bootlin.com Signed-off-by: Masahiro Yamada yamada.masahiro@socionext.com Tested-by: Richard Weinberger richard@nod.at

Applied.

Thanks,

Boris

---

Changes in v4:

• split into a very simple patch for backport candiate

drivers/mtd/nand/raw/denali_dt.c | 6 +++++- 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/nand/raw/denali_dt.c b/drivers/mtd/nand/raw/denali_dt.c index cfd33e6..5869e90 100644 --- a/drivers/mtd/nand/raw/denali_dt.c +++ b/drivers/mtd/nand/raw/denali_dt.c @@ -123,7 +123,11 @@ static int denali_dt_probe(struct platform_device *pdev) if (ret) return ret;

• denali->clk_x_rate = clk_get_rate(dt->clk);

• /*

• * Hardcode the clock rate for the backward compatibility.
  

• * This works for both SOCFPGA and UniPhier.
  

• */
  

• denali->clk_x_rate = 200000000;

ret = denali_init(denali); if (ret)