The MIPS eBPF JIT calls flush_icache_range() in order to ensure the icache observes the code that we just wrote. Unfortunately it gets the end address calculation wrong due to some bad pointer arithmetic.

The struct jit_ctx target field is of type pointer to u32, and as such adding one to it will increment the address being pointed to by 4 bytes. Therefore in order to find the address of the end of the code we simply need to add the number of 4 byte instructions emitted, but we mistakenly add the number of instructions multiplied by 4. This results in the call to flush_icache_range() operating on a memory region 4x larger than intended, which is always wasteful and can cause crashes if we overrun into an unmapped page.

Fix this by correcting the pointer arithmetic to remove the bogus multiplication, and use braces to remove the need for a set of brackets whilst also making it obvious that the target field is a pointer.

Signed-off-by: Paul Burton paul.burton@mips.com Fixes: b6bd53f9c4e8 ("MIPS: Add missing file for eBPF JIT.") Cc: Alexei Starovoitov ast@kernel.org Cc: Daniel Borkmann daniel@iogearbox.net Cc: Martin KaFai Lau kafai@fb.com Cc: Song Liu songliubraving@fb.com Cc: Yonghong Song yhs@fb.com Cc: netdev@vger.kernel.org Cc: bpf@vger.kernel.org Cc: linux-mips@vger.kernel.org Cc: stable@vger.kernel.org # v4.13+ --- arch/mips/net/ebpf_jit.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/mips/net/ebpf_jit.c b/arch/mips/net/ebpf_jit.c index 76e9bf88d3b9..0effd3cba9a7 100644 --- a/arch/mips/net/ebpf_jit.c +++ b/arch/mips/net/ebpf_jit.c @@ -1819,7 +1819,7 @@ struct bpf_prog *bpf_int_jit_compile(struct bpf_prog *prog)

/* Update the icache */ flush_icache_range((unsigned long)ctx.target, - (unsigned long)(ctx.target + ctx.idx * sizeof(u32))); + (unsigned long)&ctx.target[ctx.idx]);

if (bpf_jit_enable > 1) /* Dump JIT code */