Following error was seen when mounting a 16MByte ubifs: UBIFS error (ubi0:0 pid 1893): check_lpt_type.constprop.6: invalid type (15) in LPT node type

QSPI_IFR.TFRTYP was not set correctly. When data transfer is enabled and one wants to access the serial memory through AHB in order to: - read in the serial memory, but not a memory data, for example a JEDEC-ID, QSPI_IFR.TFRTYP must be written to '0' (both sama5d2 and sam9x60). - read in the serial memory, and particularly a memory data, TFRTYP must be written to '1' (both sama5d2 and sam9x60). - write in the serial memory, but not a memory data, for example writing the configuration or the QSPI_SR, TFRTYP must be written to '2' for sama5d2 and to '0' for sam9x60. - write in the serial memory in particular to program a memory data, TFRTYP must be written to '3' for sama5d2 and to '1' for sam9x60.

Fix the setting of the QSPI_IFR.TFRTYP field.

Fixes: 2d30ac5ed633 ("mtd: spi-nor: atmel-quadspi: Use spi-mem interface for atmel-quadspi driver") Cc: stable@vger.kernel.org # v5.0+ Reported-by: Tom Burkart tom@aussec.com Signed-off-by: Tudor Ambarus tudor.ambarus@microchip.com --- drivers/spi/atmel-quadspi.c | 10 +++++++--- 1 file changed, 7 insertions(+), 3 deletions(-)

diff --git a/drivers/spi/atmel-quadspi.c b/drivers/spi/atmel-quadspi.c index b44521d4a245..ad913212426e 100644 --- a/drivers/spi/atmel-quadspi.c +++ b/drivers/spi/atmel-quadspi.c @@ -365,10 +365,14 @@ static int atmel_qspi_set_cfg(struct atmel_qspi *aq, if (dummy_cycles) ifr |= QSPI_IFR_NBDUM(dummy_cycles);

- /* Set data enable */ - if (op->data.nbytes) + /* Set data enable and data transfer type. */ + if (op->data.nbytes) { ifr |= QSPI_IFR_DATAEN;

+ if (op->addr.nbytes) + ifr |= QSPI_IFR_TFRTYP_MEM; + } + /* * If the QSPI controller is set in regular SPI mode, set it in * Serial Memory Mode (SMM). @@ -393,7 +397,7 @@ static int atmel_qspi_set_cfg(struct atmel_qspi *aq, atmel_qspi_write(icr, aq, QSPI_WICR); atmel_qspi_write(ifr, aq, QSPI_IFR); } else { - if (op->data.dir == SPI_MEM_DATA_OUT) + if (op->data.nbytes && op->data.dir == SPI_MEM_DATA_OUT) ifr |= QSPI_IFR_SAMA5D2_WRITE_TRSFR;

/* Set QSPI Instruction Frame registers */