A64-OLinuXino-eMMC uses 1.8V for eMMC supply. This is done via a triple jumper, which sets VCC-PL to either 1.8V or 3.3V. This setting is different for boards with and without eMMC.

This is not a big issue for DDR52 mode, however the eMMC will not work in HS200/HS400, since these modes explicitly requires 1.8V.

Fixes: 94f68f3a4b2a ("arm64: dts: allwinner: a64: Add A64 OlinuXino board (with eMMC)") Cc: stable@vger.kernel.org # v5.4 Signed-off-by: Stefan Mavrodiev stefan@olimex.com --- Changes for v2: - Restore the original eMMC vmmc-supply property

arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts index 96ab0227e82d..121e6cc4849b 100644 --- a/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts +++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-olinuxino-emmc.dts @@ -15,7 +15,7 @@ pinctrl-names = "default"; pinctrl-0 = <&mmc2_pins>; vmmc-supply = <&reg_dcdc1>; - vqmmc-supply = <&reg_dcdc1>; + vqmmc-supply = <&reg_eldo1>; bus-width = <8>; non-removable; cap-mmc-hw-reset;