The OPP structure must not be used out of the rcu protected section. Cache the values to be used in separate variables instead.
Signed-off-by: Viresh Kumar viresh.kumar@linaro.org Tested-by: Dave Gerlach d-gerlach@ti.com --- drivers/base/power/opp/core.c | 16 +++++++++++++--- 1 file changed, 13 insertions(+), 3 deletions(-)
diff --git a/drivers/base/power/opp/core.c b/drivers/base/power/opp/core.c index 4c7c6da7a989..056527a3fb4e 100644 --- a/drivers/base/power/opp/core.c +++ b/drivers/base/power/opp/core.c @@ -584,6 +584,7 @@ int dev_pm_opp_set_rate(struct device *dev, unsigned long target_freq) struct clk *clk; unsigned long freq, old_freq; unsigned long u_volt, u_volt_min, u_volt_max; + unsigned long old_u_volt, old_u_volt_min, old_u_volt_max; int ret;
if (unlikely(!target_freq)) { @@ -633,6 +634,14 @@ int dev_pm_opp_set_rate(struct device *dev, unsigned long target_freq) return ret; }
+ if (IS_ERR(old_opp)) { + old_u_volt = 0; + } else { + old_u_volt = old_opp->u_volt; + old_u_volt_min = old_opp->u_volt_min; + old_u_volt_max = old_opp->u_volt_max; + } + u_volt = opp->u_volt; u_volt_min = opp->u_volt_min; u_volt_max = opp->u_volt_max; @@ -677,9 +686,10 @@ int dev_pm_opp_set_rate(struct device *dev, unsigned long target_freq) __func__, old_freq); restore_voltage: /* This shouldn't harm even if the voltages weren't updated earlier */ - if (!IS_ERR(old_opp)) - _set_opp_voltage(dev, reg, old_opp->u_volt, - old_opp->u_volt_min, old_opp->u_volt_max); + if (old_u_volt) { + _set_opp_voltage(dev, reg, old_u_volt, old_u_volt_min, + old_u_volt_max); + }
return ret; }