Ah yes, wrong address, but when scanning for responding IP's I also could only see 4 nodes.
So, power cycled:
matthew-hart@linaro-gateway:~$ cxmanage ipinfo calxeda02-00-03 Getting IP addresses... 1 successes | 0 errors | 0 nodes left | .
IP info from calxeda02-00-03 Node 0: 192.168.2.75 Node 1: 192.168.2.78 Node 2: 192.168.2.81 Node 3: 192.168.2.84 Node 4: 192.168.2.87 Node 5: 192.168.2.90 Node 6: 192.168.2.93 Node 7: 192.168.2.96 Node 8: 192.168.2.99 Node 9: 192.168.2.102 Node 10: 192.168.2.105 Node 11: 192.168.2.108 Node 12: 192.168.2.111 Node 13: 192.168.2.114 Node 14: 192.168.2.117 Node 15: 192.168.2.120 Node 16: 192.168.2.123 Node 17: 192.168.2.126 Node 18: 192.168.2.129 Node 19: 192.168.2.132 Node 20: 192.168.2.135 Node 21: 192.168.2.138 Node 22: 192.168.2.141 Node 23: 192.168.2.144
Much better.
Thanks all, Matt.
On 20 August 2013 10:24, Steve Capper steve.capper@linaro.org wrote:
Hi Matt, I think you meant: calxeda02-00-03? I get the following when checking for IPs (Matt Gretton-Dann was at my desk asking about Calxeda02 just now :-) ): steve-capper@linaro-gateway:~$ cxmanage ipinfo calxeda02-00-03 Getting IP addresses... 1 successes | 0 errors | 0 nodes left | .
IP info from calxeda02-00-03 Node 0: 192.168.2.75 Node 1: 192.168.2.78 Node 2: 192.168.2.81 Node 3: 192.168.2.84
i.e. only one card active?
So I think it is a good idea to power cycle.
Cheers,
Steve
On 20 August 2013 10:13, Matt Hart matthew.hart@linaro.org wrote:
Hi all,
For reasons I'm yet to establish, the management node of calxeda02 has become unresponsive and unreachable on our network.
linaro-gateway:~$ cxmanage macaddrs calxeda02-00-02 Getting MAC addresses... 0 successes | 1 errors | 0 nodes left | .
Command failed on these hosts calxeda02-00-02 : [Errno -2] Name or service not known
I've checked the obvious things like cables etc, but our DHCP logs show 3 nodes making requests within the last couple of days and they all use the same link cable so it doesn't seem a physical networking issue.
If nobody has any reservations or comments, I'd like to power cycle the
box
as a first step.
Matt