11 Jan
2017
11 Jan
'17
5:11 p.m.
On Wed, Jan 11, 2017 at 03:05:03PM +0100, Marcin Wojtas wrote:
2017-01-11 14:11 GMT+01:00 Leif Lindholm leif.lindholm@linaro.org:
On Thu, Jan 05, 2017 at 12:03:41PM +0100, Marcin Wojtas wrote:
This commit adds following Xenon custom configuration for Armada 70x0 board after it was enabled in the driver:
AP HW block Xenon controller:
- 3.3V power supply
- 4-bit bus width
- 'slow mode' enabled
CP0 HW block Xenon controller:
- 1.8V power supply
- 4-bit bus width
- 'slow mode' disabled
Just to clarify - so even though we add 8-bit bus support, we don't have a way to test it yet?
Not yet, but I'm going to submit new SoC support (Armada80x0), where it's used.
Which is OK, just wanted to make sure it wasn't a typo.
/ Leif