Hello Jakub,
On Tue, Aug 13, 2024 at 03:37:16PM -0700, Jakub Kicinski wrote:
On Tue, 13 Aug 2024 11:38:16 -0700 Breno Leitao wrote:
Adds a selftest that creates two virtual interfaces, assigns one to a new namespace, and assigns IP addresses to both.
It listens on the destination interface using socat and configures a dynamic target on netconsole, pointing to the destination IP address.
The test then checks if the message was received properly on the destination interface.
We're getting a:
SKIP: directory /sys/kernel/config/netconsole does not exist. Check if NETCONSOLE_DYNAMIC is enabled
https://netdev-3.bots.linux.dev/vmksft-net-drv-dbg/results/726381/4-netcons-...
Gotta extend tools/testing/selftests/drivers/net/config
Thanks, I've added the following changes in tools/testing/selftests/drivers/net/config:
CONFIG_NETCONSOLE=m CONFIG_NETCONSOLE_DYNAMIC=y
Then I was able to get the test executing running the following commands:
# vng --build --config tools/testing/selftests/net/config # vng -v --run . --user root --cpus 4 -- \ make -C tools/testing/selftests TARGETS=drivers/net \ TEST_PROGS="netcons_basic.sh" TEST_GEN_PROGS="" run_tests ..... # timeout set to 45 # selftests: drivers/net: netcons_basic.sh [ 11.172987] netdevsim netdevsim407 eni407np1: renamed from eth1 [ 12.441965] printk: legacy console [netcon_ext0] enabled [ 12.443049] netpoll: netconsole: local port 6665 [ 12.444104] netpoll: netconsole: local IPv4 address 192.168.1.1 [ 12.445281] netpoll: netconsole: interface 'eni407np1' [ 12.446299] netpoll: netconsole: remote port 6666 [ 12.447246] netpoll: netconsole: remote IPv4 address 192.168.1.2 [ 12.448419] netpoll: netconsole: remote ethernet address aa:c8:83:a5:05:b3 [ 12.450646] netconsole: network logging started [ 13.547405] netconsole selftest: netcons_GjLI0 ok 1 selftests: drivers/net: netcons_basic.sh
I will wait a bit more, and then integrate this change into v2.
Thanks for the review --breno