With SGX1 an enclave needs to be created with its maximum memory demands allocated. Pages cannot be added to an enclave after it is initialized. SGX2 introduces a new function, ENCLS[EAUG], that can be used to add pages to an initialized enclave. With SGX2 the enclave still needs to set aside address space for its maximum memory demands during enclave creation, but all pages need not be added before enclave initialization. Pages can be added during enclave runtime.
Add support for dynamically adding pages to an initialized enclave, architecturally limited to RW permission at creation but allowed to obtain RWX permissions after trusted enclave runs EMODPE. Add pages via the page fault handler at the time an enclave address without a backing enclave page is accessed, potentially directly reclaiming pages if no free pages are available.
The enclave is still required to run ENCLU[EACCEPT] on the page before it can be used. A useful flow is for the enclave to run ENCLU[EACCEPT] on an uninitialized address. This will trigger the page fault handler that will add the enclave page and return execution to the enclave to repeat the ENCLU[EACCEPT] instruction, this time successful.
If the enclave accesses an uninitialized address in another way, for example by expanding the enclave stack to a page that has not yet been added, then the page fault handler would add the page on the first write but upon returning to the enclave the instruction that triggered the page fault would be repeated and since ENCLU[EACCEPT] was not run yet it would trigger a second page fault, this time with the SGX flag set in the page fault error code. This can only be recovered by entering the enclave again and directly running the ENCLU[EACCEPT] instruction on the now initialized address.
Accessing an uninitialized address from outside the enclave also triggers this flow but the page will remain inaccessible (access will result in #PF) until accepted from within the enclave via ENCLU[EACCEPT].
Reviewed-by: Jarkko Sakkinen jarkko@kernel.org Tested-by: Jarkko Sakkinen jarkko@kernel.org Tested-by: Haitao Huang haitao.huang@intel.com Tested-by: Vijay Dhanraj vijay.dhanraj@intel.com Signed-off-by: Reinette Chatre reinette.chatre@intel.com --- Changes since V4: - Add Vijay's Tested-by tag. - Add Haitao's Tested-by tag. - Do not attempt direct reclaim if no EPC pages available during page fault. mmap_lock is already held in page fault handler so attempting to take it again while running sgx_reclaim_pages() has risk of deadlock.
Changes since V3: - Add Jarkko's Reviewed-by tag. - Add Jarkko's Tested-by tag. - Call sgx_encl_grow() with sgx_encl->lock held as made possible with change to sgx_encl_grow() making calling of reclaimer optional.
Changes since V2: - Remove runtime tracking of EPCM permissions (sgx_encl_page->vm_run_prot_bits) (Jarkko). - Move export of sgx_encl_{grow,shrink}() to separate patch. (Jarkko) - Use sgx_encl_page_alloc(). (Jarkko) - Set max allowed permissions to be RWX (Jarkko). Update changelog to indicate the change and use comment in code as created by Jarkko in: https://lore.kernel.org/linux-sgx/20220306053211.135762-4-jarkko@kernel.org - Do not set protection bits but let it be inherited by VMA (Jarkko)
Changes since V1: - Fix subject line "to initialized" -> "to an initialized" (Jarkko). - Move text about hardware's PENDING state to the patch that introduces the ENCLS[EAUG] wrapper (Jarkko). - Ensure kernel-doc uses brackets when referring to function.
arch/x86/kernel/cpu/sgx/encl.c | 117 +++++++++++++++++++++++++++++++++ 1 file changed, 117 insertions(+)
diff --git a/arch/x86/kernel/cpu/sgx/encl.c b/arch/x86/kernel/cpu/sgx/encl.c index 5b5affe1a538..1b9086648b2e 100644 --- a/arch/x86/kernel/cpu/sgx/encl.c +++ b/arch/x86/kernel/cpu/sgx/encl.c @@ -290,6 +290,112 @@ struct sgx_encl_page *sgx_encl_load_page(struct sgx_encl *encl, return __sgx_encl_load_page(encl, entry); }
+/** + * sgx_encl_eaug_page() - Dynamically add page to initialized enclave + * @vma: VMA obtained from fault info from where page is accessed + * @encl: enclave accessing the page + * @addr: address that triggered the page fault + * + * When an initialized enclave accesses a page with no backing EPC page + * on a SGX2 system then the EPC can be added dynamically via the SGX2 + * ENCLS[EAUG] instruction. + * + * Returns: Appropriate vm_fault_t: VM_FAULT_NOPAGE when PTE was installed + * successfully, VM_FAULT_SIGBUS or VM_FAULT_OOM as error otherwise. + */ +static vm_fault_t sgx_encl_eaug_page(struct vm_area_struct *vma, + struct sgx_encl *encl, unsigned long addr) +{ + vm_fault_t vmret = VM_FAULT_SIGBUS; + struct sgx_pageinfo pginfo = {0}; + struct sgx_encl_page *encl_page; + struct sgx_epc_page *epc_page; + struct sgx_va_page *va_page; + unsigned long phys_addr; + u64 secinfo_flags; + int ret; + + if (!test_bit(SGX_ENCL_INITIALIZED, &encl->flags)) + return VM_FAULT_SIGBUS; + + /* + * Ignore internal permission checking for dynamically added pages. + * They matter only for data added during the pre-initialization + * phase. The enclave decides the permissions by the means of + * EACCEPT, EACCEPTCOPY and EMODPE. + */ + secinfo_flags = SGX_SECINFO_R | SGX_SECINFO_W | SGX_SECINFO_X; + encl_page = sgx_encl_page_alloc(encl, addr - encl->base, secinfo_flags); + if (IS_ERR(encl_page)) + return VM_FAULT_OOM; + + mutex_lock(&encl->lock); + + epc_page = sgx_alloc_epc_page(encl_page, false); + if (IS_ERR(epc_page)) { + if (PTR_ERR(epc_page) == -EBUSY) + vmret = VM_FAULT_NOPAGE; + goto err_out_unlock; + } + + va_page = sgx_encl_grow(encl, false); + if (IS_ERR(va_page)) + goto err_out_epc; + + if (va_page) + list_add(&va_page->list, &encl->va_pages); + + ret = xa_insert(&encl->page_array, PFN_DOWN(encl_page->desc), + encl_page, GFP_KERNEL); + /* + * If ret == -EBUSY then page was created in another flow while + * running without encl->lock + */ + if (ret) + goto err_out_shrink; + + pginfo.secs = (unsigned long)sgx_get_epc_virt_addr(encl->secs.epc_page); + pginfo.addr = encl_page->desc & PAGE_MASK; + pginfo.metadata = 0; + + ret = __eaug(&pginfo, sgx_get_epc_virt_addr(epc_page)); + if (ret) + goto err_out; + + encl_page->encl = encl; + encl_page->epc_page = epc_page; + encl_page->type = SGX_PAGE_TYPE_REG; + encl->secs_child_cnt++; + + sgx_mark_page_reclaimable(encl_page->epc_page); + + phys_addr = sgx_get_epc_phys_addr(epc_page); + /* + * Do not undo everything when creating PTE entry fails - next #PF + * would find page ready for a PTE. + */ + vmret = vmf_insert_pfn(vma, addr, PFN_DOWN(phys_addr)); + if (vmret != VM_FAULT_NOPAGE) { + mutex_unlock(&encl->lock); + return VM_FAULT_SIGBUS; + } + mutex_unlock(&encl->lock); + return VM_FAULT_NOPAGE; + +err_out: + xa_erase(&encl->page_array, PFN_DOWN(encl_page->desc)); + +err_out_shrink: + sgx_encl_shrink(encl, va_page); +err_out_epc: + sgx_encl_free_epc_page(epc_page); +err_out_unlock: + mutex_unlock(&encl->lock); + kfree(encl_page); + + return vmret; +} + static vm_fault_t sgx_vma_fault(struct vm_fault *vmf) { unsigned long addr = (unsigned long)vmf->address; @@ -309,6 +415,17 @@ static vm_fault_t sgx_vma_fault(struct vm_fault *vmf) if (unlikely(!encl)) return VM_FAULT_SIGBUS;
+ /* + * The page_array keeps track of all enclave pages, whether they + * are swapped out or not. If there is no entry for this page and + * the system supports SGX2 then it is possible to dynamically add + * a new enclave page. This is only possible for an initialized + * enclave that will be checked for right away. + */ + if (cpu_feature_enabled(X86_FEATURE_SGX2) && + (!xa_load(&encl->page_array, PFN_DOWN(addr)))) + return sgx_encl_eaug_page(vma, encl, addr); + mutex_lock(&encl->lock);
entry = sgx_encl_load_page_in_vma(encl, addr, vma->vm_flags);