On 2022-07-07 12:28, Vladimir Oltean wrote:
On Wed, Jul 06, 2022 at 02:25:02PM +0200, Hans Schultz wrote:
For convenience the function mv88e6xxx_g1_atu_op() has been used to read ATU violations, but the function has other purposes and does not enable the possibility to read the FID when reading ATU violations.
The FID is needed to get hold of which VID was involved in the violation, thus the need for future purposes to be able to read the FID.
Make no mistake, the existing code doesn't disallow reading back the FID during an ATU Get/Clear Violation operation, and your patch isn't "allowing" something that wasn't disallowed.
It would only read 0 the way it worked. And I don't understand why mv88e6xxx_g1_atu_op() writes the FID?
The documentation for the ATU FID register says that its contents is ignored before the operation starts, and it contains the returned ATU entry's FID after the operation completes.
So the change simply says: don't bother to write the ATU FID register with zero, it doesn't matter what this contains. This is probably true, but the patch needs to do what's written on the box.
Writing 0 to the ATU fID register resulted in a read giving zero of course.
Please note that this only even matters at all for switches with mv88e6xxx_num_databases(chip) > 256, where MV88E6352_G1_ATU_FID is a dedicated register which this patch avoids writing. For other switches, the FID is embedded within MV88E6XXX_G1_ATU_CTL or MV88E6XXX_G1_ATU_OP. So _practically_, for those switches, you are still emitting the GET_CLR_VIOLATION ATU op with a FID of 0 whether you like it or not, and this patch introduces a (most likely irrelevant) discrepancy between the access methods for various switches.
Please note that this observation is relevant for your future changes to read back the FID too. As I said here: https://patchwork.kernel.org/project/netdevbpf/patch/20220524152144.40527-4-... you can't just assume that the FID lies within the MV88E6352_G1_ATU_FID register, just look at the way it is packed within mv88e6xxx_g1_atu_op(). You'll need to unpack it in the same way.
So I need a new function to read the FID that mimics mv88e6xxx_g1_atu_op() as far as I understand?