Expand the documentation on the KUnit debugfs filesystem on the run_manual.rst page.
Add section describing how to access results using debugfs.
Add section describing how to run tests after boot using debugfs.
Signed-off-by: Rae Moar rmoar@google.com --- Changes since v3: - Change the introduction of the debugfs section - Add detail to not being able to run concurrently or run with init data
Documentation/dev-tools/kunit/run_manual.rst | 51 ++++++++++++++++++-- 1 file changed, 47 insertions(+), 4 deletions(-)
diff --git a/Documentation/dev-tools/kunit/run_manual.rst b/Documentation/dev-tools/kunit/run_manual.rst index e7b46421f247..699d92885075 100644 --- a/Documentation/dev-tools/kunit/run_manual.rst +++ b/Documentation/dev-tools/kunit/run_manual.rst @@ -49,9 +49,52 @@ loaded.
The results will appear in TAP format in ``dmesg``.
+debugfs +======= + +KUnit can be accessed from userspace via the debugfs filesystem (See more +information about debugfs at Documentation/filesystems/debugfs.rst). + +If ``CONFIG_KUNIT_DEBUGFS`` is enabled, the KUnit debugfs filesystem is +mounted at /sys/kernel/debug/kunit. You can use this filesystem to perform +the following actions. + +Retrieve Test Results +===================== + +You can use debugfs to retrieve KUnit test results. The test results are +accessible from the debugfs filesystem in the following read-only file: + +.. code-block :: bash + + /sys/kernel/debug/kunit/<test_suite>/results + +The test results are printed in a KTAP document. Note this document is separate +to the kernel log and thus, may have different test suite numbering. + +Run Tests After Kernel Has Booted +================================= + +You can use the debugfs filesystem to trigger built-in tests to run after +boot. To run the test suite, you can use the following command to write to +the ``/sys/kernel/debug/kunit/<test_suite>/run`` file: + +.. code-block :: bash + + echo "any string" > /sys/kernel/debugfs/kunit/<test_suite>/run + +As a result, the test suite runs and the results are printed to the kernel +log. + +However, this feature is not available with KUnit suites that use init data, +because init data may have been discarded after the kernel boots. KUnit +suites that use init data should be defined using the +kunit_test_init_section_suites() macro. + +Also, you cannot use this feature to run tests concurrently. Instead a test +will wait to run until other tests have completed or failed. + .. note ::
- If ``CONFIG_KUNIT_DEBUGFS`` is enabled, KUnit test results will - be accessible from the ``debugfs`` filesystem (if mounted). - They will be in ``/sys/kernel/debug/kunit/<test_suite>/results``, in - TAP format. + For test authors, to use this feature, tests will need to correctly initialise + and/or clean up any data, so the test runs correctly a second time.