The jq command is used in vlan_bridge_binding.sh, if it is not supported, the test will spam the following log.

# ./vlan_bridge_binding.sh: line 51: jq: command not found # ./vlan_bridge_binding.sh: line 51: jq: command not found # ./vlan_bridge_binding.sh: line 51: jq: command not found # ./vlan_bridge_binding.sh: line 51: jq: command not found # ./vlan_bridge_binding.sh: line 51: jq: command not found # TEST: Test bridge_binding on->off when lower down [FAIL] # Got operstate of , expected 0

The rtnetlink.sh has the same problem. It makes sense to check if jq is installed before running these tests. After this patch, the vlan_bridge_binding.sh skipped if jq is not supported:

# timeout set to 3600 # selftests: net: vlan_bridge_binding.sh # TEST: jq not installed [SKIP]

Fixes: dca12e9ab760 ("selftests: net: Add a VLAN bridge binding selftest") Fixes: 6a414fd77f61 ("selftests: rtnetlink: Add an address proto test") Signed-off-by: Wang Liang wangliang74@huawei.com Reviewed-by: Hangbin Liu liuhangbin@gmail.com --- tools/testing/selftests/net/rtnetlink.sh | 2 ++ tools/testing/selftests/net/vlan_bridge_binding.sh | 2 ++ 2 files changed, 4 insertions(+)

diff --git a/tools/testing/selftests/net/rtnetlink.sh b/tools/testing/selftests/net/rtnetlink.sh index dbf77513f617..163a084d525d 100755 --- a/tools/testing/selftests/net/rtnetlink.sh +++ b/tools/testing/selftests/net/rtnetlink.sh @@ -1466,6 +1466,8 @@ usage: ${0##*/} OPTS EOF }

+require_command jq + #check for needed privileges if [ "$(id -u)" -ne 0 ];then end_test "SKIP: Need root privileges" diff --git a/tools/testing/selftests/net/vlan_bridge_binding.sh b/tools/testing/selftests/net/vlan_bridge_binding.sh index db481af9b6b3..e8c02c64e03a 100755 --- a/tools/testing/selftests/net/vlan_bridge_binding.sh +++ b/tools/testing/selftests/net/vlan_bridge_binding.sh @@ -249,6 +249,8 @@ test_binding_toggle_off_when_upper_down() do_test_binding_off : "on->off when upper down" }

+require_command jq + trap defer_scopes_cleanup EXIT setup_prepare tests_run