Failed boards:
bbb multi_v7_defconfig : FAILED 1:23.91 panda multi_v7_defconfig : FAILED 1:36.50
Successful boards:
apc vt8500_v6_v7_defconfig : passed 1:16.37 arndale exynos_defconfig : passed 1:06.63 bbb omap2plus_defconfig : passed 1:33.66 beaver tegra_defconfig : passed 0:52.49 beaver multi_v7_defconfig : passed 0:52.59 capri bcm_defconfig : passed 0:42.37 capri multi_v7_defconfig : passed 0:44.28 cubie sunxi_defconfig : passed 0:54.99 cubie multi_v7_defconfig : passed 0:58.99 cubie2 sunxi_defconfig : passed 0:52.28 cubie2 multi_v7_defconfig : passed 1:01.89 cubie2 multi_lpae_defconfig : passed 0:52.46 cubox dove_defconfig : warnings 1:10.99 dalmore tegra_defconfig : passed 1:22.41 dalmore multi_v7_defconfig : passed 1:19.22 dalmore multi_lpae_defconfig : passed 1:17.79 panda omap2plus_defconfig : passed 1:17.04 sama5 sama5_defconfig : passed 1:54.11 seaboard tegra_defconfig : passed 1:01.72 seaboard multi_v7_defconfig : passed 1:08.56 snow exynos_defconfig : passed 1:20.30 snowball u8500_defconfig : passed 1:31.37 snowball multi_v7_defconfig : passed 2:12.65 trimslice tegra_defconfig : passed 0:56.37 trimslice multi_v7_defconfig : passed 1:03.14 wandboard imx_v6_v7_defconfig : passed 0:54.49 wandboard multi_v7_defconfig : passed 1:12.59
Board legend is available at http://arm-soc.lixom.net/boards.html
Last entries of failed logs below:
========================================================================
Board bbb-multi_v7_defconfig failure log: -------------------------------------------------
TFTP from server 172.16.1.3; our IP address is 172.16.1.117 Filename 'arm-soc/v3.13-rc4-669-g0c10152/multi_v7_defconfig/zImage'. Load address: 0x80200000 Loading: *################node: bbb status: on ################################################# ################################################################# ################################################################# ################################################################# ##################################### 1.2 MiB/s done Bytes transferred = 4349360 (425db0 hex) U-Boot# setenv serverip 172.16.1.3 setenv serverip 172.16.1.3 U-Boot# tftp 0x81f00000 arm-soc/v3.13-rc4-669-g0c10152/multi_v7_defconfig/dtbs/am335x-boneblack.dtb tftp 0x81f00000 arm-soc/v3.13-rc4-669-g0c10152/multi_v7_defconfig/dtbs/am335x-boneblack.dtb link up on port 0, speed 100, full duplex Using cpsw device TFTP from server 172.16.1.3; our IP address is 172.16.1.117 Filename 'arm-soc/v3.13-rc4-669-g0c10152/multi_v7_defconfig/dtbs/am335x-boneblack.dtb'. Load address: 0x81f00000 Loading: *## 1 MiB/s done Bytes transferred = 17911 (45f7 hex) U-Boot# setenv bootargs console=ttyO0,115200 root=/dev/mmcblk0p2 rootwait rw debug earlyprintk setenv bootargs console=ttyO0,115200 root=/dev/mmcblk0p2 rootwait rw debug earlyprintk U-Boot# printenv bootargs printenv bootargs bootargs=console=ttyO0,115200 root=/dev/mmcblk0p2 rootwait rw debug earlyprintk U-Boot# bootz 0x80200000 - 0x81f00000 bootz 0x80200000 - 0x81f00000 ## Flattened Device Tree blob at 81f00000 Booting using the fdt blob at 0x81f00000 Using Device Tree in place at 81f00000, end 81f075f6
Starting kernel ...
~$off # PYBOOT: Exception: timeout
========================================================================
Board panda-multi_v7_defconfig failure log: -------------------------------------------------
[ 1.415191] omap-dma-engine 4a056000.dma-controller: freeing channel for 62 [ 1.422546] platform 4809c000.mmc: Driver omap_hsmmc requests probe deferral [ 1.429962] omap_hsmmc 480d5000.mmc: could not find pctldev for node /ocp/pinmux@4a100040/pinmux_wl12xx_pins, deferring probe [ 1.441864] platform 480d5000.mmc: Driver omap_hsmmc requests probe deferral [ 1.449523] sdhci-pltfm: SDHCI platform and OF driver helper [ 1.456359] usbcore: registered new interface driver usbhid [ 1.462188] usbhid: USB HID core driver [ 1.469146] TCP: cubic registered [ 1.472625] NET: Registered protocol family 17 [ 1.477508] Key type dns_resolver registered [ 1.482360] Power Management for TI OMAP4+ devices. [ 1.487548] Power Management for TI OMAP4. [ 1.491851] OMAP4 PM: u-boot >= v2012.07 is required for full PM support [ 1.498992] Registering SWP/SWPB emulation handler [ 1.504821] reg-fixed-voltage wl12xx_vmmc.10: could not find pctldev for node /ocp/pinmux@4a100040/pinmux_wl12xx_gpio, deferring probe [ 1.517639] platform wl12xx_vmmc.10: Driver reg-fixed-voltage requests probe deferral [ 1.526245] omap_i2c 48070000.i2c: could not find pctldev for node /ocp/pinmux@4a100040/pinmux_i2c1_pins, deferring probe [ 1.537750] platform 48070000.i2c: Driver omap_i2c requests probe deferral [ 1.537841] omap_i2c 48072000.i2c: could not find pctldev for node /ocp/pinmux@4a100040/pinmux_i2c2_pins, deferring probe [ 1.556793] platform 48072000.i2c: Driver omap_i2c requests probe deferral [ 1.556884] omap_i2c 48060000.i2c: could not find pctldev for node /ocp/pinmux@4a100040/pinmux_i2c3_pins, deferring probe [ 1.575805] platform 48060000.i2c: Driver omap_i2c requests probe deferral [ 1.576416] omap_i2c 48350000.i2c: could not find pctldev for node /ocp/pinmux@4a100040/pinmux_i2c4_pins, deferring probe [ 1.594818] platform 48350000.i2c: Driver omap_i2c requests probe deferral [ 1.602569] omap-dma-engine 4a056000.dma-controller: allocating channel for 62 [ 1.610260] omap-dma-engine 4a056000.dma-controller: allocating channel for 61 [ 1.617858] omap_hsmmc 4809c000.mmc: vmmc regulator missing [ 1.617950] omap-dma-engine 4a056000.dma-controller: freeing channel for 61 [ 1.631042] omap-dma-engine 4a056000.dma-controller: freeing channel for 62 [ 1.638397] platform 4809c000.mmc: Driver omap_hsmmc requests probe deferral [ 1.646087] omap_hsmmc 480d5000.mmc: could not find pctldev for node /ocp/pinmux@4a100040/pinmux_wl12xx_pins, deferring probe [ 1.657989] platform 480d5000.mmc: Driver omap_hsmmc requests probe deferral [ 1.665557] /home/build/work/batch/drivers/rtc/hctosys.c: unable to open rtc device (rtc0) [ 1.674468] spear_cpufreq: Invalid cpufreq_tbl [ 1.679168] ALSA device list: [ 1.679168] No soundcards found. [ 1.686431] omap_uart 48020000.serial: no wakeirq for uart2 [ 1.686431] Waiting for root device /dev/mmcblk0p2... ~$off # PYBOOT: Exception: timeout